answersLogoWhite

0


Best Answer

This happened to me on a 1986 cutlass 2.5. A wire was shorting out going to the map sensor and only did it in reverse. The bracket on the alternator had rubbed a hole and only grounded when the motor moved, when placed in reverse. I fixed it temporary with electrical tape.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why would a car stall in reverse?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would a car stall shifting from park to reverse?

A car might stall when shifting from park to reverse if the idle is set too low. It is also possible that the engine stalls because it is not fully warmed up before shifting from park to reverse.


Why would a car stall in drive but not in reverse?

Because reverse is a lower ratio gear than drive and puts less load on the engine.


Is it safe to drive a car if reverse not working?

How would you get your car in and out of your driveway? How would you get out of a parking stall unless you pulled through and there was no curb or car blocking you? It is not uncommon to find yourself in a tight area where all you can do is reverse to get out while driving. I would say it is not safe.


Car stall in reverse gear only?

There are several reasons that a car may stall only in reverse, the best way to narrow down the issue is to use a diagnostic tool. The diagnostic tool will show which sensors on the transmission may be malfunctioning enough to stall the engine.


Why would a car only stall in reverse?

I'm no mechanic, BUT that happened on my Taurus when the fuel pump was not functioning properly. Best to take it in.


Why would a car stall in a car wash?

if you have a cracked distributor cap then water would get inside it and make your car stall.


Why would a car stall when you hit the breaks?

because if you stop immediately then the car will stall.


What causes an automatic transmission not to idle?

If you mean each time you engage car in any gear forward or reverse & it immediately stalls - you have a bad torque converter. Start engine, put foot on brake, put car in NEUTRAL, if it DOES NOT stall, but it does stall if you repeat this test when you put car in drive or reverse = bad torque converter - It's called a "stall test"


Why would an engine seem to almost stall when put in reverse but idle fine in park engine is 94 351 windsor?

Why would it stall or almost stall in Reverse but not in Drive? How long since it's received a tune-up and thorough check-up? How is the compression?


Why does your car stall when you press the gas pedal or you put it in reverse?

youre lifting the clutch up to quick


Would a bad torque converter make a car stall?

yes a bad converter will make car stall


When ran on empty why would my car stall?

out of fuel?