The length will be one yard. The width will be the other dimension from woven/knit edge to woven/knit edge.
1 yard of fabric has a length of 1 yard but the width of the fabric is not specified and so the question cannot be answered.
You would need one yard. Fabric is cut in one-fourth yard cuts. Three-fourths of a yard would be 27" which is not enough. To get the 30" length, you would need one yard and would have 6" left over in length. Most fabrics are at least 36" wide, so you would have some fabric left over in width also.
It is simply the length of the fabric so 1 [linear] yard.
Fabric is usually either 45" or 54" width (depends on the bolt), and one yard is 36" length. So 0.50 yards of fabric is either: 18" length x 45" wide OR 18" length x 54" wide
C
A yard of cloth measures 36 inches in length. It is equivalent to 3 feet and is commonly used in textiles and fabric measurements. In metric terms, one yard is approximately 0.9144 meters.
one half yard?
Assuming each square has a side length of 6 inches, you can cut 16 squares from 1 yard of fabric. This is because 1 yard is equal to 36 inches, and each square requires 6 inches of fabric for one side.
One yard of fabric is 36" long, and varies in width. If you have 45" wide fabric, you need 22" of fabric (less than one yard). The fabric store can help you with that.
A fabric measure is typically referred to as a "yard" or "meter," depending on the measurement system used. In the textile industry, fabric is often sold by the yard or meter, which indicates the length of the material. Additionally, terms like "bolt" or "roll" may refer to the way fabric is packaged and sold, with a bolt being a specific length of fabric wrapped around a core.
A yard of fabric is 36 inches long. If the fabric is 60 inches wide, you can calculate the number of 10-inch squares that fit into the width and length. In the width, 60 inches divided by 10 inches equals 6 squares, and in the length, 36 inches divided by 10 inches equals 3 squares. Therefore, the total number of 10-inch squares in a yard of fabric is 6 (width) x 3 (length) = 18 squares.
If the table is 36" round, I'm assuming you are talking about diameter. I would simply get the same length as the width of the fabric you want to use. Then the drape will be the same....