A #8 conductor is rated at 40 amps. Wattage is the product of amps x volts. As you can see the voltage is needed in this question to answer it. In the electrical trade I have never come across the terminology watt amp. Volt amp, yes.
A 1200 watt resistive load hair dryer is equivalent to 1.2 kw (kilowatts).
Technically, yes. Practically, no. Amplifiers and speakers are rated by the maximum amount of power (and at what impedance) they can handle. A 1200 watt amplifier will eventually destroy a 1000 watt speaker if it is operated at maximum power. In normal use, however, you rarely even get close to maximum rating.
Yes, a 1200 watt amp can power a 300 watt box. The wattage of the amp refers to its maximum power output, so it can deliver up to 1200 watts if needed. As long as the amp is set up properly and not pushed to its maximum capacity, it can safely power a 300 watt box.
You should use a 4 guage wire. There is a handy chart located at http://www.the12volt.com/info/recwirsz.asp which lists the proper wire size for differing wattages.
For a 1200-watt amplifier, the appropriate gauge of speaker wire typically depends on the length of the wire run. For runs up to 50 feet, 12-gauge wire is generally recommended to handle the power without significant loss. If the run exceeds 50 feet, consider using 10-gauge wire to ensure optimal performance and minimize voltage drop. Always consult a wire gauge chart for specific applications to ensure safety and efficiency.
1000-1200 watt peak amp its rated at 350RMS and breaks at 1200 watts so ether a 500-600RMS should do fine and sound killer
MW is a unit of power just like kW 1MW = 1000 kW 1 mega-watt = 1000 kilo-watt Watt is a measurement of power. watt-hour is a unit of energy 1 mega-watt-hour = 1000 kilo-watt-hour
800 watt should be fine
do amps get pushed? Normally a 1200 watt amp would need driving with less than 12 watts of audio.
yea man it will be alright. just dont turn the amp all the way up or u will catch the wires on fire and u really dont wanna do that.
Yes, you can use 14-2 gauge wire for a 1000 watt microwave, as long as it is on a 15 amp circuit. It is important to check the manufacturer's specifications and local electrical codes to ensure proper wiring for the appliance.
It will power two 400 watt lamps.