Yes, a 1200 watt amp can provide good bass for 2 Kicker CVR 12-inch subwoofers. Make sure to set the amp gain correctly, match the impedance of the subwoofers with the amp, and use a proper enclosure for optimal performance.
Using a 3000 watt amp with a 300 watt speaker can potentially damage the speaker due to overpowering it. The excessive power can cause the speaker to blow out or distort the sound quality. It's important to match the power ratings of the amp and speaker to prevent damage.
A 300 watt bulb requires a circuit breaker of at least 2.5 amps. This can be determined by dividing the power (300 watts) by the voltage (120 volts). However, considering normal breaker sizes, a 5 amp breaker would be sufficient for a 300 watt bulb.
This is determined by how you wire your subs to your amp. If you get an amp that's bridgeable to mono, then you can wire your subs in series. You will get much more thump if you do it this way. However, make certain that your amp is bridgeable, and stable down to 2 or even 1 Ohms. Check with the dealer you buy from. When wired the way I mentioned, a 300-Watt amp will probably do nicely!
It depends on the power and impedance rating of the 12-inch speakers. If both speakers are rated for 175 watts and the amp can handle the impedance of the speakers, then the 350 watt amp should be able to power both speakers effectively.
1200 Watt wiring is more than enough for an 800 Watt amp. The rating of the sub doesn't make any difference to the cables. If you want to use the sub to its rated power you should get a bigger amp. If the amp can only give out 800 Watts and the sub can take 1100 Watts then you can put a bigger amp on. It is still going to be loud as with an 800 Watt amp. I have a 300 watt amp with a 1200 Watt sub and people hear me coming.
It's actually a good idea to have a speaker that can handle higher wattage than the amp can produce.
They can be as loud, as the amp is not delivering 600 watts. The 10" sub rated at 600 watts is able to withstand more power.
800 watt should be fine
Yes, a 1200 watt amp can provide good bass for 2 Kicker CVR 12-inch subwoofers. Make sure to set the amp gain correctly, match the impedance of the subwoofers with the amp, and use a proper enclosure for optimal performance.
crutchfield has a wiring diagram for all kinds of configurations, check it out.
Depends on what your willing to spend.. For two 1200 watt subs I would go with a 1200 watt amp and run both of then 600 watts ( you don't want to always run subs to full power, because the voice coil might blow or you will light your subs on fire). If your feeling brave you can run a 2000 watt amp 0_o that will annoy your neighbours, but make your car bump!
Using a 3000 watt amp with a 300 watt speaker can potentially damage the speaker due to overpowering it. The excessive power can cause the speaker to blow out or distort the sound quality. It's important to match the power ratings of the amp and speaker to prevent damage.
Yes, but the amp is too powerful and if turned up to full volume will blow the speakers.
1000-1200 watt peak amp its rated at 350RMS and breaks at 1200 watts so ether a 500-600RMS should do fine and sound killer
A #8 conductor is rated at 40 amps. Wattage is the product of amps x volts. As you can see the voltage is needed in this question to answer it. In the electrical trade I have never come across the terminology watt amp. Volt amp, yes.
Yes!!!!! Do not try it unless you want to get to very hurt!!!!!!!!