0
You can, but the problem is your speakers will not give their optimal sound quality because your Amplifier is too weak for the speakers. So,buy an amplifier with an output power rating high then 400w.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What will a 3000 watt amp do to a 300 watt speaker?
It will have the potential to over drive the speaker elements and can cause distortion and potential speaker damage.
Can a 1200 watt amp power a 1300 watt sub?
It's actually a good idea to have a speaker that can handle higher wattage than the amp can produce.
Can you use a 52 watt stereo with 1000 watt speakers?
sure you can, your amp will only deliver 52 watts to the speaker, more importend would be the impedance of the speaker . it should be equal to what your amp has! may be 8 ohms
How big an amp should I use to power 500 watt speaker PA monitor?
1000W will be suitable. See the specifications of speaker.
Can you hook a 200 watt amplifier to a 120 watt sub woofer?
Yes it should be all right. Ratings for amp/speakers are approximate but as a rule it is preferable for the speaker to be rated higher than the amp.
What speaker match to 500 watts amp?
All car speakers will go well with a 500 Watt amp, but for the best effect, get a power subwoofer.
What happens to a 200 watt speaker with a amp that pushes 240 watts?
the speaker will be pushed past its farthest flex point and it will eventually start tearing the actual speaker and will break
How much watt amplifier should be used to run 800 rms subwoofers 2 ten inch 400rms each?
1600 watt amp. your power amp should 2x the rms value. To varify, check JBL's website and look in one of their speaker manuals, it will show you their speaker wattage and then show you the recommended power amp wattage.
Is a 250 watt mono channel amp good enough for 2 100 watt speakers?
Monoblock amp? No. Only 1 channel which is good for one speaker, or one sub. What you need is either a 2 channel amp or a bridgeable 4 channel amp, which would be overkill anyway. If the amp you have is 2 channel, it would be ideal.
Is a 250 watt mono channel amp good enough for 2 100 watt amps?
Monoblock amp? No. Only 1 channel which is good for one speaker, or one sub. What you need is either a 2 channel amp or a bridgeable 4 channel amp, which would be overkill anyway. If the amp you have is 2 channel, it would be ideal.
Will it sound bad if you use a 400 watt speaker with a 300 watt amp?
No, that's just the maximum capacity of the speakers. You can always run them at less than their maximum rating.
Can you use a 600 watt amp on a 300 watt speaker?
AS long as the impedance is a match you can use any speake with any amp. But if the power ratings are too mismatched don't expect it to sound that good. If the amp is stronger than the speaker, the speaker can be damaged if you crank the amp up high. And if you hook an amp to a too strong speaker the amp might have trouble powering it properly.
