Yes, a 1200 watt amp can power a 300 watt box. The wattage of the amp refers to its maximum power output, so it can deliver up to 1200 watts if needed. As long as the amp is set up properly and not pushed to its maximum capacity, it can safely power a 300 watt box.
Yes, are we talking rms or max? If its rms you will have no problem. well the amp is a 1500 watt max but 350wx1 rms in 4 ohm
1200 Watt wiring is more than enough for an 800 Watt amp. The rating of the sub doesn't make any difference to the cables. If you want to use the sub to its rated power you should get a bigger amp. If the amp can only give out 800 Watts and the sub can take 1100 Watts then you can put a bigger amp on. It is still going to be loud as with an 800 Watt amp. I have a 300 watt amp with a 1200 Watt sub and people hear me coming.
800 watt should be fine
Yes, a 1200 watt amp can provide good bass for 2 Kicker CVR 12-inch subwoofers. Make sure to set the amp gain correctly, match the impedance of the subwoofers with the amp, and use a proper enclosure for optimal performance.
crutchfield has a wiring diagram for all kinds of configurations, check it out.
Depends on what your willing to spend.. For two 1200 watt subs I would go with a 1200 watt amp and run both of then 600 watts ( you don't want to always run subs to full power, because the voice coil might blow or you will light your subs on fire). If your feeling brave you can run a 2000 watt amp 0_o that will annoy your neighbours, but make your car bump!
1000-1200 watt peak amp its rated at 350RMS and breaks at 1200 watts so ether a 500-600RMS should do fine and sound killer
A #8 conductor is rated at 40 amps. Wattage is the product of amps x volts. As you can see the voltage is needed in this question to answer it. In the electrical trade I have never come across the terminology watt amp. Volt amp, yes.
Yes!!!!! Do not try it unless you want to get to very hurt!!!!!!!!
you just need one, a general rule of thumb is that the wattage on your amp should be double the wattegae on your sub, hence if you have a 1200 watt sub you'll need a 2400 watt amp
The best way to hook up a single 12 inch dvc to a 1200 watt amp is to use an MTX thunder box.