220=2*pi*r
110/pi=r
The length of an arc equals he angle (in radians) times the radius. Divide the length by the radius, and that gives you the ange. Measure out the angle on a protractor and draw the length of the radius at the begining and end of the angle. Then draw theportion of the circle with its center at the location ofthe angle and extending out to the radius.
Curved surface area of a cone = pi*radius*slant length
Divide the area by pi then square root your answer which will give the radius of the circle and use 2*pi*radius to find the circumference.
The integral from 0 to 2 pi of your constant value r will equal the circumference. This will be equal to 2*pi*r. This can be derived because of the following: Arc length = integral from a to b of sqrt(r^2-(dr/dtheta)^2) dtheta. By substituting the equation r = a constant c, dr/dtheta will equal 0, a will equal 0, and b will equal 2pi (the radians in a circle). By substitution, this becomes the integral from 0 to 2 pi of sqrt(c^2 + 0)dtheta, which leads us back to the original formula.
17
The diameter of a circle is the length of a straight line that goes through the exact center of a circle. The radius of a circle is the length of a straight line that starts at the exact center and reaches the circle. The radius is half the length of the diameter.
The radius is a cord, is it not?
The length of a straight line from the centre of a circle to the edge of the circle.
Radius of a circle= Perimeter of the circle/2*pi Radius is half the diameter Radius is the length of a straight line from the center point of the circle to the edge of the circle.
They both describe a circle. The radius is the length from the middle of the circle to the edge. The diameter is the length of a straight line going through the middle of the circle edge to edge.
The length of a radius is not the length of a diameter. The diameter is two times the length of the radius.
The radius of a circle is any straight line from the centre of the circle to its circumference. The radius can also refer to the length of this line.
diameter is 2 times the length of the radius and is a line straight through the center of the circle. radius is half of the diameter and is a line from the center to a edge of the circle
By definition the radius of a circle is a straight line drawn from the centre of a circle to its circumference. If you extend that line to the opposite side of the circle it becomes the diameter. The length of the diameter is twice the length of the radius. If the radius is 1316 the diameter is 2632
The diameter is the length of a straight line, from one side of the circle to the other, passing through the centre. The radius is a straight line from the circle centre to the circle itself and is always = half the length of the diameter, so 6 * 0.5 = 3
A radius is the distance from the centre of a circle (or sphere) to its circumference (or surface). It is a straight line and has dimensions [L]. It has only a length, no volume. So there is no such furmula.
The diameter of a circle is the length of a straight line from a point on the edge of the circle passing through the center of the circle and onto a point on the opposite edge of the circle. The radius of a circle is the length of a straight line from the center of a circle to a point on the edge of the edge of the circle. So the radius of a circle is half its diameter, in this case 8cm.