Bus topology is used in banks primarily for its cost-effectiveness and ease of installation. It allows multiple devices to be connected along a single cable, simplifying the network layout and reducing the amount of cabling needed. This topology can efficiently handle the relatively low volume of data traffic typical in banking environments, making it suitable for connecting various terminals and devices. However, it's important to note that while it may be used in smaller or legacy systems, many banks are transitioning to more robust topologies for enhanced reliability and security.
ask OC transpo
The common network of bus topology is a network where clients are connected through cables called a bus. You can learn more about this at the Wikipedia. Once on the website, type "Bus network" into the search field at the top of the page and press enter to bring up the information.
The LAN topology that involves the network cable forming a single bus to which every workstation is attached is called the bus topology. In this setup, all devices share a single communication line, and data travels in both directions along the bus. The main advantage of bus topology is its simplicity and ease of installation, but it can be prone to collisions and performance issues as more devices are added. Additionally, if the main cable fails, the entire network goes down.
Ease of operation Reliability Low Cost
The networking topology that is difficult to reconfigure and where a break can disable the entire network is the bus topology. In this configuration, all devices are connected to a single central cable, or "bus," which carries data signals. If there is a break or failure in the bus, it can disrupt communication for all devices connected to it, making troubleshooting and reconfiguration more challenging compared to other topologies.
Either bus topology or star toplogy.
Bus topology is used on a LAN, or a Local Area Network. It is the cable to which the nodes connect, and it is also known as a backbone.
Bus topology
Bus topology is the most popular topology. Justify.
Bus topology LANs are very rare these days. It would be easier to use a star topology than a bus topology for a few devices.
Well, yes. Please correct your question, thanks!
So that the Signal will not reflact back due to difference of permitivity of signals that causes destructive interfrance... They are used in End of Bus topology
Bus Topology.
bus topology
Topology: physical ring of trees, logical ring
star good luck on chapter 12!
i will answer the question