0
What else can I help you with?
What happens when there is a break in the cable of the bus topology?
This sounds like a homework question.....hmmmm. Anyway- if there's a break in a bus topology, the nodes that are downstream from the break are cut-off from the rest of the network. In a ring topology, the nodes on both sides of the break will loop the path (self-healing) back towards the ring, so every node is still communicating with each other.
What type of cable would you to create a ring topology?
what type of cable would you used to create a ring topology?
What will happen when a single cable is at fault in any topology?
Mesh topology- a cable at fault not affect others. Ring topology- a cable at fault, only affect side by side, If main cable at fault ,whole system shut down. Star topology- a cable at fault, others are not affected. If Hub at fault, whole system shut down. Bus topology- main cable at fault, system will shut down. a cable at fault,will not affect others.
What network topology connects to a trunk cable?
Bus Topology.
What is the name of the device that should be attached at the end of a cable in a cable topology?
its called a cable
Which networking topology is difficult to reconfigure and a break in it disables the entire network?
The networking topology that is difficult to reconfigure and where a break can disable the entire network is the bus topology. In this configuration, all devices are connected to a single central cable, or "bus," which carries data signals. If there is a break or failure in the bus, it can disrupt communication for all devices connected to it, making troubleshooting and reconfiguration more challenging compared to other topologies.
Which network topology are connected to the same cable?
The network topology where all devices are connected to the same cable is known as a bus topology. In this setup, all nodes share the same communication line, allowing data to be transmitted along the cable. While bus topology is simple and cost-effective, it can lead to performance issues and difficulties in troubleshooting, as a failure in the main cable can disrupt the entire network.
Cables used in a star bus topology?
Star topology is like the network is done by easily adding another network and the most common cable is used unshielded twisted pair cable. For the star topology purpose, Cat5 and Cat6 cable is used because it is an unshielded and shielded twisted pair cable.
Can physical topology support multiple logical topology give reason?
physical topology support multiple logical topology because quality and speed of cable wires effect efficiency of network
What hardware does a bus topology need?
A bus topology needs a trunk cable, which is a high speed central cable to which all the nodes can be connected. If the trunk cable breaks down, however, the whole network comes to a halt.
Which topology would you use when unable to install network cable?
Wireless.
What network topology has one central cable with terminators at each end?
The network topology that features one central cable with terminators at each end is known as a bus topology. In this configuration, all devices are connected to a single linear cable, known as the bus, which facilitates communication among them. This topology is relatively easy to set up and cost-effective for small networks, but it can suffer from collision issues and is less reliable than other topologies, as a failure in the central cable can disrupt the entire network.
