in star topology , the central hub is called......
(i) active hub (ii) passive hub (iii) inactive hub (iv) live hub
A star topology.
Star topology
both hubs and switch can act as a center of a star topology
Star Topology is the most common type of network topology that is used in homes and offices. In the Star Topology there is a central connection point called the hub which is a computer hub or sometimes just a switch. In a Star Network the best advantage is when there is a failure in cable then only one computer might get affected and not the entire network.
No, because there is a hub between star topology and every station connect to that central hub. hub cause broadcast and congession since packet loss is more likely to occur. I suggest that mesh topology is more faster as there is a dedicated link to each node.
Star topology:- In this topology all PC are connected with the central device. Central may be HUB and SWITCH. Star widely use in all over word. Ring topology:- In this ring topology all PC are connected in the frame of ring are close Ring topology use MSAU each PC has a two never road one is called up Stream and called down stream. It used token passing Matterhorn which implement the token ring network. " Is the best of star topology".
A network star topology has all the clients connect to a central device, such as a hub or switch. The clients look like points of a star, hence the term star topology.
If by Star you mean a Star Topology, it is a network cabling scheme in which all nodes are individually connected to a central hub.
A star network uses a central server to route data between clients. The central server (or the switching hub) switches data around the network. Data flow between the server and the nodes will therefore be relatively low. A typical star network are mainframe computers. Star topology, also known as star network, is a computer network topology. It is a common network setup where the computers and other devices on the network are connected to a central or master computer, also known as the hub.
The physical network topology that has the inherent weakness of a single point of failure is the star topology. In a star topology, all devices are connected to a central hub or switch. If this central device fails, the entire network becomes inoperable, as all communication relies on it. This makes the network vulnerable to disruptions if the hub experiences any issues.
To construct a star topology, begin by placing a central hub or switch at the center of the network. Connect all network devices, such as computers and printers, to this central hub using individual cables. Ensure that each device has a dedicated point-to-point connection to the hub, which allows for easy management and troubleshooting. Finally, configure the network settings on each device to facilitate communication through the central hub.
pc,cables,hub,