0
No, electrical wires can only be run in parallel on wire sizes 1/0 and larger. To supply a load of 30 amps you will need #10 wire and a 30 amp breaker.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Can a remodel job be wired with romex if the home is wired with conduit?
Yes unless there were some overarching electric code reason why conduit was used in lieu of Romex. if in doubt ask an electrician.
What conduit is used in a residential residence with 15 amp wires?
You need no conduit on a residential home using Romex wiring with wooden studs. For a 15 amp circuit use 14/2 wire with a 15 amp breaker. This can only be used in bedrooms, living rooms, and dining areas. All other areas of the home require 12/2 wiring with a 20 amp breaker.
Where do usually series circuit used?
Series circuits are used in areas where the operation of the circuit is required to be linear.
What is used to measure the current in a circuit and how is it connected?
To measure the current in the circuit an ammeter is used and it is connected in series
What is a mcb and what is it used for?
mcb is master circuit breaker. it is used in the circuit for the protection of equipments from over voltage.
What are wires in a circuit covered in?
There are a variety of wire coverings depending on what the conductor is used for. There are also different wire coverings for different temperatures where the conductor will be used. To answer the question the wires in a circuit are covered in insulation.
Is Romex in conduit allowed?
No, Romex cable is not allowed to be run inside conduit. Romex cable is intended to be used in exposed or concealed applications within buildings. If conduit is used, it should contain individual THHN/THWN wires instead of Romex cable.
Can a remodel job be wired with romex if the home is wired with conduit?
Yes unless there were some overarching electric code reason why conduit was used in lieu of Romex. if in doubt ask an electrician.
What is the difference between thhn and romex?
THHN is a single-conductor wire typically used in conduit for indoor wiring, while Romex is a brand of non-metallic sheathed cable that contains multiple insulated conductors in a flexible plastic jacket. THHN must be used inside conduit, while Romex can be run along surfaces or in walls without conduit.
What is a general name used for a common household electric cable?
Modern NM/ Romex
What can a 20 amp circuit be used for?
A 20 amp circuit be used for any device that takes up to 20 amps to make it operate.
How many amps is 10-2 romex safe for?
10-2 Romex wire is typically rated for 30 amps when used in residential applications. However, the actual safe amperage will depend on the specific installation, local electrical code requirements, and the circuit protection devices employed. It is essential to consult a licensed electrician to ensure proper and safe usage.
What type of wiring would be used for exterior home lighting?
Use a # 12 exterior grade or romex
What set of lengths can be used to make a triangle?
There are many lengths that can be used to make triangles. Basically take the longest side, add the two shorter sides together, it can be a triangle as long as the 2 shorter sides added together are longer than the longest side.
Can you use a 14 romax for receptacle?
No, it is not recommended to use a 14-gauge Romex cable for receptacles. A 14-gauge wire is typically used for lighting circuits, while a 12-gauge wire is usually used for receptacles to handle the higher current requirements. It is important to match the wire size with the intended usage for safety and code compliance.
What wire is commonly used in house wiring?
Romex, All you have to do is go to a hardware store and tell them you need house wire. It comes in a box. I am not sure how many feet. If you are just looking for the gauge, they will know that too.
What is switch purpose?
A switch is used to make or break an electrical circuit.
