Answer for USA, Canada and countries running a 60 Hz supply service.
The NEC allows PVC conduit to be used for service entrance conductors. Remember that a disconnecting means must be placed as near as possible to where the conductors enter the building.
Local codes may make further restrictions. If in doubt, contact a competent local electrician for help.
<><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
PVC is cheaper but is used differently. PVC is usually baried in ground and emt usually runs exposed. You can use PVC exposed if it is schedule 80 gray PVC electrical conduit. Schedule 40 is for under ground
2 inch Rigid or IMC conduit if it's on a structure. 2 inch schedule 80 PVC conduit if it's on a wood pole.
can you used pvc pipes in a commerical business kitchen
Yes.
Yes, if it is rigid PVC conduit approved for electrical installations. Don't use PVC water pipe as it will be rejected if inspected.
For underground conduit runs, PVC is by far the better of the two conduit systems.
The "How Many Wires in PVC Conduit" chart typically accommodates up to 9 wires in a PVC conduit.
PVC is cheaper but is used differently. PVC is usually baried in ground and emt usually runs exposed. You can use PVC exposed if it is schedule 80 gray PVC electrical conduit. Schedule 40 is for under ground
The NEC PVC conduit fill table provides information on the maximum number of conductors that can be safely installed in a PVC conduit based on the size of the conduit and the size of the conductors.
The PVC conduit fill table provides information on the maximum number and size of cables that can be safely installed in a PVC conduit based on its diameter.
Schedule 80 PVC electrical conduit is a type of conduit that is thicker and stronger than Schedule 40 PVC conduit. It is designed to provide extra protection for electrical wiring in more demanding environments. The specifications for Schedule 80 PVC electrical conduit typically include a higher wall thickness, increased impact resistance, and the ability to withstand higher temperatures compared to Schedule 40 PVC conduit.
To properly connect PVC conduit to a metal box, you can use a PVC male adapter and a locknut. First, insert the male adapter into the end of the PVC conduit. Then, thread the locknut onto the male adapter and tighten it onto the metal box. This will create a secure and watertight connection between the PVC conduit and the metal box.
The conduit fill table for PVC pipes provides guidelines on the maximum number of cables or wires that can be safely installed in a PVC conduit based on its size. It helps ensure proper spacing and prevents overheating.
The PVC conduit fill chart provides information on the maximum number of cables that can be safely installed in a conduit based on the size of the conduit and the diameter of the cables.
It is not recommended to run coaxial cable in the same PVC conduit as the electric service. The electrical interference from the power lines can degrade the signal quality of the coaxial cable. It is better to run them in separate conduits to avoid interference issues.
2 inch Rigid or IMC conduit if it's on a structure. 2 inch schedule 80 PVC conduit if it's on a wood pole.
The NEC conduit fill table for PVC conduits provides guidelines on the maximum number of conductors that can be safely installed in a PVC conduit based on its size. It helps ensure proper spacing and prevents overheating of the conductors.