0
Still curious? Ask our experts.
Chat with our AI personalities
ReneChange my mind. I dare you.
Chat with Rene
RafaThere's no fun in playing it safe. Why not try something a little unhinged?
Chat with Rafa
BeauYou're doing better than you think!
Chat with BeauAdd your answer:
Earn +20 ptsQ: How high do you hang a stairway bannister?
Write your answer...
Submit
Still have questions?
Continue Learning about Electrical Engineering
What are power poles or lines?
um... isnt it kinda obvious? they are the cords that hang all over the place that carry electricity.
How high above bar do you hang pendant lights?
There is no set height. Most smaller surfaces can be lit at about 28" above the surface top, while larger surfaces may warrant a height of 32 to 34 inches. The farther away the light is, the larger pool of light it casts, but the less bright it is. Anywhere from 28 to 34 inches is best for most situations. It is really your choice.
Does plastic have a high resistance?
Yes, it has a high resistance as it is an insulator.
Why no load-speed of a dc series motor is very high?
high torque
What is high frequency tuned amplifier?
High frequency amplifier is a device which is tuned by high frequency. Tuned means the overlapping of generated frequency with that amplifier.
Trending Questions
If you have a 750 millivolt valve however the thermopile leads only generate 600 mv is that sufficient to open valve?
What happens when one light bulb goes out in a series?
What is the frequency of ARY digital on asiasat 105.5?
Why was AC invented?
How do you wire Murphy switch?
Design a synchronous 4-bit binary counter?
Will a 1000 watt generator operate a sump pump?
What is the different Rx level full and Rx level sub?
Is 4 point starter used to start and control the speed of dc shunt motor with armature resistance control?
Does a 6 amp 240 volt appliance hook up to 110?
What is intrinsic conductor?
How fast can a generator convert water into hydroelectric energy?
What is a Booster Transformer in Railway Engineering?
Why a microprocessor works in binary code on.can a microprocessor be designed to works on yes or no codes or in similar two level of codes.if not then what makes a microprocessor to understand binary.?
How does electricity move around a parallel circuit?
At what approximate percentage of the normal run speed is the start winding disconnected from the circuit?
Why a triode cannot be used as a rectifier?
Converting volt amps into btu?
What is the voltage of main electricity when it enters your house is?
Does adding resistors in series increase or decrease the overall resistance of a circuit?
Copyright ©2025 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.