Wire is rated in ampacity, You can use only 80% of the rated ampacity. Voltage and amperage are inversely proportional. So at 120 volts alternating current you safely run 1800 watts ( I have added a small safety margin). At 240 volts you can run 3600 watts. I hope this has answered you question Ampsxvolts=watts watts/volts=amps
To answer this question the voltage of the oven must be stated. Also double check on the wattage of the oven 3.55 watts seems low. Maybe it should be 3.55 kWs. Amps = Watts/Volts.
I'm assuming the electrical system is single phase, such as a home. If not, you need to hire someone to do the work for you. First, 6000 watts at 120v is 50 amps, so if your load is truly 6000 watts, 30 amps isn't enough. If your 6000 watts is 240v, which would draw 25 amps, then 30 amps is plenty. Ten gauge wire may not be placed an a breaker or fuse larger than 30 amps.
Wire size is based on the amperage the device draws. The wattage of the unit has to be included in the equation. Amps = Watts/Volts. Most homes in North America today are roughed in with a two conductor #10 cable. This size wire will allow a 30 amps. The electrical code allows this conductor to be only loaded up to 80% capacity so useful amperage is 30 x 80% = 24 amps. Watts = Amps x volts = 24 x 240 = 5760 watts. If your dryer's wattage is no larger that this a #10 conductor will be fine. If it is higher go to the next size wire which is a #8 rated at 40 amps. Same de rate has to be applied.
n you run thhn wire in a cable tray
1,200
Wire is rated in ampacity, You can use only 80% of the rated ampacity. Voltage and amperage are inversely proportional. So at 120 volts alternating current you safely run 1800 watts ( I have added a small safety margin). At 240 volts you can run 3600 watts. I hope this has answered you question Ampsxvolts=watts watts/volts=amps
W = A x V. Watts = Amps x Volts. There is not a voltage stated to multiply the 6 amps with so an answer can not be given.
10 gauge wire will only run up to 30 amps
2100 watts to run the refrigerator
About 3,731 watts.
2, but just barely. 1 would run about 1100 watts.
15 watts
A small shredder 100-200 watts.
A 12-2 wire is designed to handle up to 20 amps of current. This would be equivalent to a maximum of around 2400 watts if using a standard 120-volt circuit. It is always important to consult local electrical codes and regulations to ensure proper installation and safety.
my aircondition is 13000 btu on 220 volt ac is how many watts
it takes enough watts to make a cart run for 1 minute Doo doo it takes enough watts to make a cart run for 1 minute Doo doo it takes enough watts to make a cart run for 1 minute Doo doo