Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
It depends on the wiring, the current load in the wiring , and the distance. The NEC Code book has the charts for this.And the size of the conduit.
It depends on the wiring, the current load in the wiring , and the distance. The NEC Code book has the charts for this.And the size of the conduit.
The minimum size you can use is 3/4 conduit. The code allows for a maximum of 4 each # 6 gauge wires in a 3/4 inch pipe. You'll likely be running 3 ea # 6s, two hots and the neutral and a #10 ground wire.
A 55 watt fluorescent light only pulls 0.4 amps. Lights can be installed on a 15 amp breaker using 14/2 wire. A maximum of 1440 watts is all that is allowed on a 15 amp circuit.
The maximum collector current is normally rated to be the current at which the DC current gain (hFE) falls to 50% of its maximum value. The maximum peak current is Page 2 Operation notes Transistors Rev.A 2/7 rated at a value which ensures reliability within the maximum allowed junction temperature.
The maximum degrees of bending allowed for conduit typically ranges from 90 to 360 degrees, depending on the type and size of the conduit. It is important to consult local building codes and manufacturer specifications to determine the specific maximum degrees of bending allowed for a particular conduit. Incorrect bending can cause damage to the conduit and affect the performance of the electrical system.
All conduit shall not have more than 360 degrees for it's length between either a box, cabinet, or conduit body. Couplings count as a continuation of conduit.
Adding an extra length of shaft on the existing shaft to take extra pulleys will put an extra load on the bearings supporting the shaft. In the long term this would shorten the life of the bearings. The makers might be able to supply more information like the side-load specification for the bearings. If in doubt support the outer end of the shaft.
Yes, PVC conduit can be used underground for electrical wiring. It is a common choice due to its durability, resistance to corrosion, and affordability. Make sure to choose the correct type and size of PVC conduit that is rated for burial to ensure safety and compliance with electrical codes.
Service entrance conductors should not be installed in conduit more than 10 feet inside a residential building before entering the service panel. This helps ensure efficient delivery of electricity and compliance with safety codes. It is important to follow local electrical codes and regulations for specific guidelines.
It depends on the wiring, the current load in the wiring , and the distance. The NEC Code book has the charts for this.And the size of the conduit.
the maximum number of drives that can be installed depends upon how many drive bay slots your case has and how many SATA connections your motherboard has.
It depends on the wiring, the current load in the wiring , and the distance. The NEC Code book has the charts for this.And the size of the conduit.
"Maximum" means the most. If the maximum speed is 100, that's the fastest you are allowed to go. Characters are letters, numbers and punctuation like you see on the keyboard in front of you. If you are only allowed to write a maximum of 50 characters, then you are not allowed any more than 50. If there were a maximum of 50 characters for this answer, all I'd be allowed to say would be: "Maximum" means the most. If the maximum speed is 100, that's
Per national electrical code you are only allowed 360 degrees which is 4, 90 degree bends before having to use a pull box or termination.
255 characters maximum
at 10.2 meters height