When sizing wire, the highest amperage that the circuit may carry has to be used. In this case 80 amps will be the highest current to be applied. A #4 copper conductor with an insulation factor of 75 or 90 degrees C are both rated at 85 amps.
35 KVA generator using for load 100 meter length which cable need to used
It depends totally on the voltage used.
hawt
A 10 mm cable is most commonly used for a 500 KVA transformer, 240 volt, 3 phrase. The size of the wire that is used in a transformer is based on the voltage.
The messenger in triplex and quad is already determined by the wire size that is wrapped around it. It is the maximum span distance that you should find for the size of over head cable that is being used.
35 KVA generator using for load 100 meter length which cable need to used
Copper SE cable gauge 00 from the meter socket to the breaker panel for a 200A service. Then 8, 10, 12, and 14 gauge wire depending on the load.
The NEC has a table that shows what size cable to use with each amperage and where it can be used.
It is probably 2080, but te answer depends on the units used for 2079.
What is the standard channel size used by both cable and wireless modems?Read more: What_is_the_standard_channel_size_used_by_both_cable_and_wireless_modems
The best size is RG 6 coax. However for short runs RG 59 will work.
There is actually no specific formula used to work out cable size. In order to determine the type of cable you need and the size you need, you need to know the source of the supply, the voltage of the system, the ambient temperature, and the method you plan on laying out the cable.
The answer will depend on the size of the tiles!
8 AWG.
Yes.
blocks of what size
A meter stick is used to measure the length of fabric so that it is suitable and accurate for the amount of fabric needed based on the size required.