answersLogoWhite

0

-- 1:23

-- 2:34

-- 3:45

-- 4:56

-- 9:10

-- 10:11

-- 11:12

-- 12:13

-- Either 0:12 or 12:34

For each of these, both AM and PM.

10 times per day.

0n the 24-hr system you could also include:

  • 13:14
  • 14:15
  • 15:16
  • 16:17
  • 17:18
  • 18:19
  • 19:20
  • 20:21
  • 21:22
  • 22:23
  • 23:24
User Avatar

Wiki User

14y ago

What else can I help you with?

Continue Learning about Engineering

How can you create a circuit that counts the number of times a switch is closed?

To create a circuit that counts the number of times a switch is closed, you can use a microcontroller (like an Arduino) or a digital counter IC (like the 74HC4017). Connect the switch to a digital input pin (for the microcontroller) or to the clock input of the counter IC. Each time the switch is closed, the microcontroller can increment a variable, or the counter IC will advance its count. Finally, display the count on an LED display or through a serial monitor for the microcontroller setup.


How clock works in flip flop?

In a flip-flop circuit, the clock signal serves as a timing reference that controls when the flip-flop changes its output state. The flip-flop typically samples its input data on the rising or falling edge of the clock signal, meaning it only updates its output based on the input state at that precise moment. This synchronization ensures that changes in state only occur at specific times, allowing for reliable data storage and transfer in digital circuits. By using clock edges, flip-flops can be integrated into sequential logic circuits, enabling the design of more complex systems like registers and counters.


What is synchronous logic?

Synchronous logic is a type of digital logic circuit where the operation of the circuit is coordinated by a clock signal. All changes in the state of the circuit occur in sync with the clock's rising or falling edges, ensuring that data transitions happen at predictable times. This approach simplifies the design and analysis of circuits, as it allows for easier timing management and reduces the risk of race conditions. Common applications include flip-flops, registers, and synchronous state machines.


What describes the number of times an analog wave is measured each second during an analog-to-digital conversion?

The sampling rate


How are digital signals in radio broadcast converted to analog signals inside digital transmission equipment before sending the signals to the antenna for transmission?

The digital signals is not converted BACK to analog! it is transmitted in digital form and the receiver is converting it back to analog to drive the speakers. The signal from the microphone is converted from analog to digital with an A/D converter chip, digital signals consist of pulses of different lengths that is switching the transmitter on and off in about the same way as the old Morse code transmissions but at a much higher rate (millions of times higher)

Related Questions

On a digital clock how many times are the numbers representing the time in sequential order during one 24 hour period?

The numbers of a clock are always in sequential order


How many times would a digital clock display the same numbers in a 24-hour day?

i think its 17


How many times does the clock face show consecutive numbers?

A clock face shows consecutive numbers in two main ways: clockwise and counterclockwise. In the clockwise direction, there are 12 sets of consecutive numbers: (1, 2), (2, 3), (3, 4), (4, 5), (5, 6), (6, 7), (7, 8), (8, 9), (9, 10), (10, 11), (11, 12), and (12, 1). In the counterclockwise direction, there are also 12 sets: (1, 12), (2, 1), (3, 2), and so on. Thus, the total number of times the clock face shows consecutive numbers, considering both directions, is 24.


How many times does 5 appear in a digital clock?

many times.


What times does a digital clock show palindromes?

1:11


How do you write first you have to times all the consecutive numbers and your answer will be the highest factor of your answer better?

First, multiply the consecutive numbers. Your total will be the highest factor.


When was the first digital alarm clock invented?

The first digital alarm clock was invented in 1956 by D.E. Protzmann, an engineer at General Electric. This alarm clock featured a digital display and the ability to set specific alarm times, setting the foundation for modern digital alarm clocks.


How many times would digital clock display paired numbers?

6 paired numbers per hour, 00 11 22 33 44 55. so...144 pairs per day, 1008 pairs per week, 4032 per month, 48384 per year...how long do you plan to run this digital clock?


How many times does a digital clock show three of the same number in a day?

5 times


How many times in one day would a digital clock show a palindrome?

120 times


What is always the sum of three consecutive whole numbers?

The sum of 3 consecutive whole numbers is always equal to 3 times the middle number in that sequence.


How many times does the sum of the digits on a digital clock equal 8 on a 24-hour military clock?

There are 93 such events.