answersLogoWhite

0

What else can I help you with?

Continue Learning about Geometry

What is the standard height for a vertical grab bar next to a toilet?

usually it will be placed according to request because many elderly or handicapped have different situations. the grab bar can be placed horizontally, diagonally, or vertically-- and the height can start from about 28 inches off the floor or higher for taller persons. ADA Horz bars are 34 to 36" to the centerline of the bar. If you are mounting in an ADA location you have to get it right. The commode and bars have to go where they have to go. Do your research.


Mike has three pieces of wood Board A is 4 inches long board B is 7 inches long and board C is 13 inches long If the full length of each board is used can the three pieces of wood be placed toget?

If the question means "Can the three pieces of wood be placed together to form a triangle", which I suspect it does, the answer is No. In a triangle, any two sides must be longer than the other. 4 + 7 is not longer than 13, so they could not meet is one was joined to a different end of the 13 inch board.


If a cylinder has a height of 16 cm and a radius of 5 cm. A cone has a height of 12 cm and a radius of 4 cm. If the cone is placed inside the cylinder as shown what is the volume of the air space surr?

It is 1056 cm3.


What does this mean 44.25'' H x 71.2'' W x 29.9'' D?

Typically means: (H) Height X (W) Width X (D) Depth Normally used for measuring the size of items to be placed in a particular area.


What side of a rectangle is length and which is width?

on the left and right is the lengh, and on the top and bottom is the widthThat previous answer (above) makes no sense whatsoever.A short dictionary definition for length is "the longest dimension of something that is fixed in space". Therefore, with a 2-dimensional rectangle, when the sides are not labeled, and no other instructions are given, the LENGTH of the figure is ALWAYS going to be the LONGEST side, while the width is the shorter side. But some people incorrectly assume the LENGTH of a rectangle is always going to be the HORIZONTAL side. This is because most of the time, when a 2-dimensional rectangle is presented on paper, the length is nearly always placed on the horizontal anyway. So, unless all the terms are clearly defined or otherwise noted, ALWAYS assume the LONGEST side is the length.

Related Questions

A solid metal cube of side 6 inches is placed in a rectangular tank whose length width and height are 1and 2 and 3 feet What is the volume in cubic units of water that the tank can now hold?

5 7/8 cubic feet


A rectangular prism has a volume of 726 a square base and a height of 6 inches a cylinder is placed inside the prism what is the greatest diameter this cylinder could have?

It works out as 11 inches because the square base of the prism has 4 sides of 11 inches.


What is the standard height for a closet rod and shelf?

The standard height for a closet rod is typically around 66 inches from the floor, while the shelf above it is usually placed at a height of 12-18 inches above the rod.


How far apart should receptacle placed?

Believe they can be placed just along side one another. By code, the height is 12 inches above floor.


Where should the bifold door knob be placed for optimal functionality and aesthetics?

The bifold door knob should be placed at a height of about 36 inches from the floor for optimal functionality and aesthetics.


A physical education teacher placed yellow tape diagonally from one corner of a rectangular gymnasium to the other as shown by the dotted line. Which measure is closest to the length of the tape?

115.5 ft


What is the recommended height for chair rail installation and how high should chair rail be placed in a room?

The recommended height for chair rail installation is typically between 30 to 36 inches from the floor. Chair rail should be placed at a height that is visually appealing and practical for protecting walls from chair backs and other furniture.


How many inches from the floor should a towel bar be placed and how far from the toilet?

standard height is 36 inches and if there is available wall space you should put it as close to the sink or shower/tub as possible.


What size of dishes can be placed in the LG LMVM2085SW 2.0 CuFt Over-the-Range Microwave Oven - White?

15-inch sliding tray and 12-inch turntable for even heating, so the width of a dish could go to 15 inches and depth 12 inches , this is a large microwave coming in at 60 pounds and with dimensions of Height: 16-7/16 inches Length: 29-15/16 inches Depth: 15-5/8 inches


On what part of a cylinder would you find the soup can label?

The label is placed on the curved surface area of the cylinder. Its area can be found using the formula A = 3.14dh where d is the diameter and h is the height of the can. It is rectangular in shape.


A square photo is placed behind a piece of glass that has an area of 20 square inches. To the nearest hundredth what length of frame is needed to go around all edges of the glass?

Area of a square is length2. Therefore length is square root of 20 which is 4.47 inches


What is the ideal height for a closet rod and shelf in order to maximize storage space and functionality?

The ideal height for a closet rod is typically around 66-72 inches from the floor, allowing for easy access to hanging clothes. The shelf above the rod should be placed at a height of 12-18 inches above the rod to maximize storage space and functionality.