2 pints = 1 quart. 4 quarts = 1 gallon.
So 4*12 = 48 quarts.
The time it takes to fill a 30-gallon hot water heater depends on the water supply pressure and flow rate. On average, if the flow rate is around 4 to 6 gallons per minute, it would take approximately 5 to 8 minutes to fill the heater completely. However, this can vary based on the plumbing setup and water pressure in your home.
you drill a hole in it then fill it with water then pour it into a cup and measure it
The volume is 23,430 cubic inches which would require 101.4 gallons to fill.
Approximately it would take 3,600,456 balls in order to fill a jumbo jet plane
Simple 3x14=42cubic inches so at a rate of 9cubic inches per minute. 42ci/9ci/m=4.7m then you multiply 4.7 by 60 to convert to seconds as it is the standard form for most physics. 4.7x60=282s so it would take 282 seconds to fill the cylinder
There are 4 quarts in 1 gallon. So you would need 4 quarts of water to fill a gallon.
regular pitcher --- quarts
Filter service would be about 5 quarts. Dry fill is about 12.Filter service would be about 5 quarts. Dry fill is about 12.
20 quarts would be dry fill, it may not take all of it to fill.
1 gallon = 4 quarts 2 gallons = 8 quarts . . 5 gallons = 20 quarts
10 quarts and then clean it out
Since there are 4 quarts in a gallon, 5 gallons is equal to 20 quarts (5 gallons x 4 quarts/gallon = 20 quarts). If Kari uses a quart container, she will need to fill it 20 times to make 5 gallons of water. Therefore, Kari will have to fill the container 20 times.
Service fill approx 5 quarts. Dry fill approx 9 quarts. Mopar ATF+4Service fill approx 5 quarts. Dry fill approx 9 quarts. Mopar ATF+4
5 quarts service fill 9 quarts dry fill
Dry fill is about 9 quarts.Dry fill is about 9 quarts.
Dry fill is about 9 quartsDry fill is about 9 quarts
5 quarts for filter service. 9 quarts dry fill approx.5 quarts for filter service. 9 quarts dry fill approx.