An ohm per square depends on the effective area of a sheet. Let us look at a sheet that is W um by L um. A square is a calculation which answers how many squares of size min(W,L) by min(W,L) are in an area.
In other words how many squares are in an area defined by W and L is max(W or L) divided by min(W or L).
The number of microns would require multiplication by at least 1 dimension.
14 grams per micron
You have to divide by a trillion. So x g/m2 is 0.000000000001x g/um2
A micron is a measure of length and a cubic meter is a measure of volume, thus the two can not be equated.
if it is ohm meter and not ohm per metre; divide by 1,000,000 to convert ohm to megaohm, then divide by 1000 further to convert metre into kilometre
1.171
14 grams per micron
Vanguard card manufacturer states that 230 micron= 180gsm and 280micron=220gsm
Not possible to answer ! A micron - is a linear measurement... GSM is a measurement of weight !
You are trying to convert linear measurement to square, which is wrong. Conductivity is receprocial to resistivity; EC=1/ER the proper conversion is 1 Sm/cm=1 Ohm cm=100 Ohm m, but not Ohms per square.. Follow this link for discussion on the topic and for on-line calculators for converting electrical conductivity units. http://landviser.us/phpBB3/viewtopic.php?f=4&t=3
You can't ! Microns are measurements of length - gsm is a unit of weight !
You have to divide by a trillion. So x g/m2 is 0.000000000001x g/um2
GSM (grams per square meter) is a unit of measurement used for the weight of paper or fabric. A micron (ยตm) is a unit of length equal to one millionth of a meter. To convert GSM to microns, you would need to know the density of the material in question. The relationship between GSM and microns is not a direct conversion and would depend on the specific material being measured.
the answer is ohms
Converting between microns and grams per square meter is not straightforward as they measure different things - microns measure thickness while grams per square meter measure mass per unit area. To convert between the two, you would need to know the density of the material in question. Once you know the density, you can use the formula: grams per square meter = microns thickness * density.
The TDA85600 is a class-D amplifier chip that can deliver up to 50 watts per channel into a 4-ohm load or 30 watts per channel into an 8-ohm load.
No. of openings per square inch of wire mesh is specifies the mesh size and its again depends on wire dia also. If the number of openings per square inch is more then partical size which it can pass through the filter will be less. For example for 325 mesh size, where in 44 micron size of particle can get filter. In 200 mesh size 74 micron size of particle will get filter.
A micron is a measure of length and a cubic meter is a measure of volume, thus the two can not be equated.