0
Yes, if the joint between the 2 width of pipes is made to be tightly closed so that no leakage would occur. The best would be to use a connector with a 1 inch diameter at one end and a diameter of 1.5 inches at the other end. Or maybe, if the 2 pipes are vertical, to put the 1 inch pipe into the 1.5 inches pipe and seal the 2 pipes with a good amount of resistant tape so that the water will go straight from one pipe to the other with no leakage. But with hot water draining from the washer, even with the cold water, the tape solution is probably just a temporary solution, because the tape would break down after some time.
What else can I help you with?
How many quarts of an inch in half inch?
Two quarters of an inch are in a half inch.
How do you write half inch?
1/2" Or Half Inch of 50% of 1 inch
How many feet and inches are in a half a inch?
there are 1\24 of a foot in a half an inchthere are 1\2 of an inch in a half an inch
What is half an inch on a glass?
Same as half an inch anywhere else.
What is more one eighth of a centimeter or half an inch?
Half an inch.
How do you change a bathtub drain to a laundry washer drain?
Washing machines pump out a large volume of water and todays standards require a 2 inch drain pipe. Bathtubs generally have a one and one half inch drain. So bathtub drain will have to be increased to 2", including trap and 18 to 24" standpipe to operate correctly, and connected to the closest existing 2" line or larger line. Same 11/2 venting can be used.
What would cause the old 4-inch drain pipe to overflow when the washer drains after installing a new washing machine and how can you fix it?
Partial blockage. Snake the drain.
Front load washer drain size?
The outlet pipe needs to be a minimum of two inches and then expanding to the four inch main line
Where is radiator drain on 2004 gmc savana?
The 2004 GMC radiator drain is located on the bottom of the radiator. The radiator drain plug can be removed with a half inch ratchet.
Will inch and a half pipe have enough run off for a shower drain?
Absolutely NOT you 2" minimum
Where is the radiator drain plug on a 2006 Ford Taurus?
The 2006 Ford Taurus radiator drain plug is located on the bottom of the radiator. The drain plug can be removed with a half inch ratchet.
How do you figure the pitch for a new drain for a washer with a length of approx 50 feet to sewer hub?
The building code where I live requires a drain pipe to slope approximately 1/4 inch per foot (+ or - 1/8 inch). The recommended pitch for a 50 foot drain would be 12-1/2 inches.
Where is the rear drain hole in a 2001 Honda Odyssey?
The 2001 Honda Odyssey rear and drain hole is located on the bottom of the rear end. The drain plug can be removed with a half inch ratchet.
My washer and dryer are currently in my basement and I would like to install it on the main floor but don't know how to install the pipes for the drain to still go into the basement drain?
Without knowing the layout or type of drain pipe and location, it is impossible to give a good answer. Drill a hole in the floor and run the drain with PVC. Drains should fall 1/8 to 1/4 of an inch for every foot of distance. Horizontal distance. There may be a drain line that is closer to the first floor location that you can tap into. Washer drain does not need a vent, it gets it's venting around the washer hose.
What to use for slow draining shower?
Use kettle hot water or plunge the drain with a basin plunger or use a 2 inch spring wire to loosen waste inside the pipe
How do you drain the gas tank on your Yamaha Grizzly 660 ATV?
Get a rubber hose that is about half inch in diameter and siphon gas out
How do you change oil on a 4 hp Briggs and stratton pressure washer?
There is usually a square 1/2 inch plug under the crank-case to drain the oil. The you replace it with the correct amount.
