0
Add your answer:
Earn +20 pts
27 minutes before 7 oclock is 33 minutes past 5 oclock?
NO. It is 33 minutes past SIX o'clock.
When Providing a recommendation to your commander what is the best way to cover your six o'clock position?
Prior to a recommendation, collaborate with your team members and experts in the field to form a consensus on the best alternative.
How do you calculate the angle formed by the hands of the clock at 3 oclock 5 oclock 11 oclock?
get yourself a cartesian circle, or just look at one online and translate it from there 3,6,9, and 12 would all be 90 deg increments.
What is the palindrome for twelve oclock midday?
noon
How do you say it is ten oclock and it is eleven oclock in french?
It is ten o'clock: il est dix heures;it is eleven o'clock: il est onze heures.
What time is it when the hour hand and the minute hand of a clock are at right angles?
nine oclock and six oclock
Is six oclock ok in spanish?
'A las seis - vale?'
27 minutes before 7 oclock is 33 minutes past 5 oclock?
NO. It is 33 minutes past SIX o'clock.
Where is the crank position sensor on the 2006 Chevrolet trailblazer?
7 oclock position behind the crankshaft pulley
How do you say i have tea at six oclock in french?
Je prends le thé à six heures
Where in the world does six plus seven equal one?
in mod 12 which is the same as clock time... 6 oclock plus seven = 1 oclock
Cam gear position 1989 240sx?
if you mean when installing a timing chain, the keyway or square notch should be at 12 oclock and the mark should be at 3 oclock
Where is the camshaft position sensor on a 2001 4.3vortec Chevy s10?
on the distributor @ 2 oclock
What is the on position of the petcock on a harley?
The LONG end of the petcock valve is the indicator of the positioning of the valve. 6'oclock is MAIN 3'oclock is OFF 12'oclock is RESERVE
How do you Replace rear brake pads on 1994 buick regal?
i Have wheel and tire off caliper is visible. Caliper is at 9 OCLOCK TO 11 OCLOCK. Only nut visible on back side of 9 OCLOCK position. How do I remove pads? Phil K
When should ball joints be relaced on a 1998 crv?
Ball joints only really need to replaced when they are going bad. Usually you can tell if you put one hand on the 12 oclock position and the other on the 6 oclock position and try to wiggle the the tire. If it wiggles this way then ball joints are going bad. (Jack the vehicle up first). If you put one hand on the 3 oclock and the other in the 9 oclock position and wiggle it and it moves then the tie rods are going bad. If the whole tire moves in and out then the bearings are usually going bad. Hope this helps.
Where should the timing mark on the cam gear and the timing mark on the crank gear be to be in time on give n picture?
The crank gear should be in the 12: oclock position & the cam gear should be in the 6: oclock position facing each other this is top dead center on compression stroke.
