Want this question answered?
Be notified when an answer is posted
Simply work out the area of a section of cable.........
You can easily fix these by taking a look at the Video Cable in the back of your screen. If you wriggle it about it will work but if you can, see if you can unscrew it and then push it in a little bit more. Nothing is wrong with the power, just the Video Cable.
go to page 42
Try a good eraser. I know the pink ones work.
I measure the distance I travel to work, the length of cable required to install an antenna, the time required to haul my present mass up the tower, and how I will satisfy my capacity for liquid refreshment when the job is done.
ck transmission gear selector on transmission. follow cable from shifter to (usually) top of trans. it is electronic
what colour fuse make the heater work in citreon saxo 1.1
the heater doesnt work in my saxo dont know where the fuse or relay is
The first and cheapest thing that comes to mind: is the shift cable still intact? There is a cable between the gear selector in the cab and the gear lever on the transmission. Crawl under the car, put someone inside to work the gears when you tell them to, find the gear lever, and have your friend move the gear selector. If the gear lever on the transmission does not move, the cable is broken.
Blower motor working? Check coolant level System airbound? Bad thermostat? Control cable not adjusted or working properly? Selector switch not working?
Set both "Selector" and "Temperature" to clean. Move lever to right to "Lock." Hit "Enter" button twice. Now I just hope I remember how to unlock and open it once it has cooled. I think you hit cancel twice and move Selector and Temperature to off.
Set both "Selector" and "Temperature" to clean. Move lever to right to "Lock." Hit "Enter" button twice. Now I just hope I remember how to unlock and open it once it has cooled. I think you hit cancel twice and move Selector and Temperature to off.
Most auto parts retailers should have something that will work for you.
Sends power to the selector causing the door inside the unit to open and close swapping tanks.
If it's an auto, you could just get an aftermarket cable shifter from a speed shop.
The vent selection is controlled by a stiff wire that pushes or pulls mechanical flaps inside the dash to channel the air. If you can't control the air flow it could be that the cable is detached on either end, or that one of the flaps inside/underneath the dash is broken or jammed. If your selector lever moves smoothly, it's likely that your cable has become disconnected. If the selector jams, it's probably a flap and will need some dashboard disassembly.
if both the inside and outside door handles work then the cable that opens the door automaticlyis jamed in the moter. Replace the auto open moter or like I did cut the cable and use the door manuly.the cable and auto moter is located under the trim on the passenger side in the rear hatch area