yes
Chat with our AI personalities
First, divide the circumference by Pi (about 3.1416): 68 / 3.1416 = 21.65 cm. This is the diameter. Now, divide the diameter by two to get the radius: 21.65 / 2 = 10.825 cm.The radius is: 10.825 cmNote: The result will vary slightly depending on the value you use for Pi
In certain formulas, including most that involve circles, you will see 'pi'. This pi always has the same value, approximately 3.14159... However, this number is irrational, which means it never terminates (ends) or repeats. But what exactly is pi? Pi is the ratio between any circle's circumference and its diameter. This ratio is always the same, no matter how big or small the circle is, but the degree of precision might vary depending on how big the circle is. Why is Pi useful? Pi allows us to calculate the diameter or area of any circle, but also has many other uses. In order to use these formulas, though, we need to define the terms we are using. Circumference - the distance around the circle Diameter - the length of a straight line segment that passes through the center of the circle Radius - the distance from the center of the circle to the circle itself To calculate the circumference, multiply the diameter by pi (3.14...) To calculate the area, square the radius, then multiply this by pi (3.14...) In symbols: Circumference = diameter x pi Area = (radius)2 x pi Hope this helped.
Because the circumference can vary from 68 to 70 centimeters, the volume is approximately 5310 to 5792 cubic centimeters(324 to 353.5 cubic inches).Circumference 68 cm = Radius 34/pi = Area 5309.77 cm3Circumference 70 cm = Radius 35/pi = Area 5792.19 cm3
What do you mean by "arc length of a circle"? If you mean the arc length between two adjacent vertices of the inscribed polygon, then: If the polygon is irregular then the arc length between adjacent vertices of the polygon will vary and it is impossible to calculate and the angle between the radii must be measured from the diagram using a protractor if the angle is not marked. The angle is a fraction of a whole turn (which is 360° or 2π radians) which can be multiplied by the circumference of the circle to find the arc length between the radii: arc_length = 2πradius × angle/angle_of_full_turn → arc_length = 2πradius × angle_in_degrees/360° or arc_length = 2πradius × angle_in_radians/2π = radius × angle_in_radians If there is a regular polygon inscribed in a circle, then there will be a constant angle between the radii of the circle between the adjacent vertices of the polygon and each arc between adjacent vertices will be the same length; assuming you know the radius of the circle, the arc length is thus one number_of_sides_th of the circumference of the circle, namely: arc_length_between_adjacent_vertices_of_inscribed_regular_polygon = 2πradius ÷ number_of_sides
A set of points in a plan that are equally distanced from a fixed point is called a circle. equation of a circle is: (x - h)2 + (y - k)2 = r2 Center = (h, k) Radius = r Since Radius (can vary for different circles on that plan) is at equal distance throughout the plan we can therefore say that a set of points in a plan that are equally distanced from a fixed point is called a circle.