use your ruler to measure the sides
It depends on the type of ruler you are using. Depends if you are using a just metric unit ruler or if you are using a yard/meter stick. The measurements should be written along the edge of the ruler.
A ruler shows set measurements, either in inches or millimeters. You can draw a straight line using the edge of a ruler. Use a ruler to measure the size of a piece of typing paper.
None. A metric ruler would not show inches, as these are not a metric measurements. It would show millimetres and centimetres.
No. Ruler is a noun, either a government head or a measuring bar.
a pencil are a piece a paper things that's are about the same size as a chocolate bar
LINEAR!! I googled it for a project! Good luck!
If you look at the ruler you will see any tabs that have been manually set, as they will be on the ruler. Default tabs are shown below the ruler.If you look at the ruler you will see any tabs that have been manually set, as they will be on the ruler. Default tabs are shown below the ruler.If you look at the ruler you will see any tabs that have been manually set, as they will be on the ruler. Default tabs are shown below the ruler.If you look at the ruler you will see any tabs that have been manually set, as they will be on the ruler. Default tabs are shown below the ruler.If you look at the ruler you will see any tabs that have been manually set, as they will be on the ruler. Default tabs are shown below the ruler.If you look at the ruler you will see any tabs that have been manually set, as they will be on the ruler. Default tabs are shown below the ruler.If you look at the ruler you will see any tabs that have been manually set, as they will be on the ruler. Default tabs are shown below the ruler.If you look at the ruler you will see any tabs that have been manually set, as they will be on the ruler. Default tabs are shown below the ruler.If you look at the ruler you will see any tabs that have been manually set, as they will be on the ruler. Default tabs are shown below the ruler.If you look at the ruler you will see any tabs that have been manually set, as they will be on the ruler. Default tabs are shown below the ruler.If you look at the ruler you will see any tabs that have been manually set, as they will be on the ruler. Default tabs are shown below the ruler.
ruler
There is no ruler bar in MS Excel. That is an MS Word function.
just get a ruler and go to town.
Centimetres and millimetres are the metric measurements used on a metric ruler.
To record measurements using a ruler, place the ruler next to the object to be measured. Ensure that the zero mark on the ruler aligns with one end of the object. Read the measurement where the other end of the object falls on the ruler and record it in the appropriate units.
No, but measurements are shown.
use your ruler to measure the sides
use the ruler as a simple balance and put an iron bar at each end. if they are the same, the ruler will not tilt and the heavier bar must be the third one. If they are different, then the heavier bar is the one that tilts the ruler down.
error bar