answersLogoWhite

0


Best Answer

The placement of steel reinforcing is dependent on the requirements of the strength and load-bearing of the concrete. A structural engineer should be contacted in this regard.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you estimate the placing of rebars?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why rebars are capped?

To prevent injury.


What words have letters b r r e a s?

rebars


How do you estimate long it would take to construct a cubic meter by placing one centimeter cube at a time show all calculations?

How do you estimate long it would take to construct a cubic meter by placing one centimetre cube at a time show all calculations?


How can I get an estimate on how much it would cost to repair my car?

You can get an estimate by placing a call or going into the repair shop or auto body shop and requesting a rough estimate on the cost it would take to repair your car


Comparison between BS and ASTM specification for steel rebars?

C 11 specification


What is the constant value from cubic meter of concrete to determine weight of rebar?

There is no constant value for the ratio of the rebars and concrete volume. The rebars depends on the structural designer's safety factor and the factors affecting the framing like wind, earthquake and soil.


In two way slab which rebars has a wider spacing the middle strip or the column strip?

Middle strip


What the unit weight of the rebars 16mm?

The unit weight of 16 mm reinforcement is 1.58 kg/m


What is the standard size of beam for a 2 story house?

350x450mm with 12-16mm rebars on 5m span


What is the meaning of waist slab?

Waist slab is used in case of stairs. The rebars are bent at some angles on which steps are built.


What is unit weight in kg of rebars per 60MPa of one cubic meter of reinforced concrete?

The unit weight of rebars is typically around 7.85 kg/m³. In a reinforced concrete mix with a compressive strength of 60 MPa, the amount of reinforcement steel used is usually between 1-2% of the total volume of concrete. Therefore, the weight of rebars per cubic meter of reinforced concrete at 60 MPa would be approximately 78.5 kg/m³ to 157 kg/m³.


How many rebars you need to purchase for a 100 ft wall When the bars are placed 2' - 0 on center and horizontal?

That would depend on the height of the wall...