This length (diagonal) = sq.rt ( l2 + b2 ) where 'l' is length of the rectangle and 'b' is the breadth of the rectangle.
Wiki User
∙ 15y agoIf the sides of a rectangle (not rectangular) are X and Y units, then the corner to corner length - the diagonal - is sqrt(X2 + Y2)
The simple answer is that a rectangle IS NOT always a square. A square is always a rectangle, though, because it has 4 corner angles of 90 degrees, and opposite sides are parallel and equal in length.
10x2
The term "length" is usually used for the rectangle's longest side.
rectangle is the "special name" of a shape with 4 corners (square). triangles are split in 3 groups. right triangle, one corner is 90 degrees equilateral triangle, every corner is 60 degrees isosceles triangle, two sides have the same length
If the sides of a rectangle (not rectangular) are X and Y units, then the corner to corner length - the diagonal - is sqrt(X2 + Y2)
Similar to a rectangle Oppisate sides must be equal in length, however unlike a rectangle the corner angles do not need to be 90 degrees
The simple answer is that a rectangle IS NOT always a square. A square is always a rectangle, though, because it has 4 corner angles of 90 degrees, and opposite sides are parallel and equal in length.
A square is classified as a rectangle with four corner angles.
The length of the rectangle is 18cm. The width of the rectangle is 9cm.
The length of a rectangle is typically considered to be the longer of the two sides, also referred to as the longer dimension. It is measured along the longer side of the rectangle from one end to the other.
if the length is 36 on a rectangle then what is the width of the rectangle
Diagonal of a rectangle or square = square root of ( length2 + width2 )
The width and length of a rectangle are two of its main dimensions. The width is the measurement of the shorter side of the rectangle, while the length is the measurement of the longer side. The area of a rectangle is calculated by multiplying the width by the length.
A = lw Area of a rectangle = length times width
width=9 length=18
Use RECTANGLE to draw a rectangle.You can specicy length.width.area and revolved parameter,you can also control the corner point type on the rectangle.Use POLYGON to draw a polygon.Polygons are closed polylines comprised of a minimum of three and a maximum of 1,024 equal-length sides.To draw a rectangleDo one of the following:Choose Draw > Rectangle.On the Draw 2D toolbar, click the Rectangle tool.Type rectangle, and then press Enter.Specify one corner of the rectangle.Specify the opposite corner of the rectangle.