where is .39 on a ruler
On a standard ruler, each inch is typically divided into 16 equal parts, known as sixteenths of an inch. To represent .35 on a ruler, you would first convert it to a fraction, which is 35/100 or 7/20. This means that .35 is 7/20 of an inch on the ruler, which would be slightly less than halfway between the 5/16 and 6/16 marks.
You look at the markings on its edge.
They are equal
One fourth of 1 inch. Look at a ruler and divide a half inch in half-that's a quarter inch.
12/16 is 3/4 13/16 will be a hair to the right of 3/4
where is .39 on a ruler
The 4th dash on a ruler represents 4/16 of an inch, which is equivalent to 1/4 of an inch.
i inch
On a standard ruler, each inch is divided into 16 equal parts, also known as sixteenths of an inch. Therefore, 0.9 inches on a ruler would be 9/10 of an inch, or 9 marks out of the 16 on the ruler. This would typically fall between the 13th and 14th mark on the ruler, depending on the specific design of the ruler.
11/16
0.66 on a ruler represents 0.66 inches or 66 hundredths of an inch. It would fall between the 5/8 inch mark and the 11/16 inch mark on a standard ruler.
On a standard ruler, each inch is typically divided into 16 equal parts, known as sixteenths of an inch. To represent .35 on a ruler, you would first convert it to a fraction, which is 35/100 or 7/20. This means that .35 is 7/20 of an inch on the ruler, which would be slightly less than halfway between the 5/16 and 6/16 marks.
You will not be able to see 0.79 of an inch on a US ruler. The best you can hope for is 0.8 inches. On a ruler, an inch is usually divided into 10 or 16 parts - the smaller, unnumbered marks between the inch marks. You can get 32 divisions on tape measures but they are unusual on rulers. Select a part of the ruler in which each inch is divided into 10 parts. Eight of them will make 0.8 inch. You will not be bale to tell the difference between 0.8 inch and 0.79 inches by eye!
1.18 inches on a ruler would be located between the 1 inch and 2 inch markings on the ruler. It would be slightly closer to the 1 inch mark than the 2 inch mark. Keep in mind that most rulers are divided into 16 equal parts per inch, with each tick mark representing 1/16 of an inch. So, on a standard ruler, the 1.18 inches mark would be located slightly beyond the 18/16 (1.125) mark and slightly before the 19/16 (1.1875) mark.
2.5 cm looks like about 1 inch on a ruler
On a standard ruler, .35 inches would be located between the 1/4 inch mark and the 3/8 inch mark. It would be closer to the 1/4 inch mark, but not quite reaching the 3/8 inch mark. .35 inches is equivalent to 9 millimeters, so it would be slightly less than halfway between the 1/4 inch and 3/8 inch marks on the ruler.