The straight line that best fits the data on a coordinate plane is the Line Of Best Fit.
"Divide line 1 by line 2" typically refers to a mathematical operation where the numerical value or expression represented by line 1 is divided by the value or expression represented by line 2. This operation can be used in various contexts, such as solving equations, calculating ratios, or analyzing data. The result will yield a new value that represents how many times line 2 fits into line 1.
line in data is y=-2X+6 The perpendicular line will have a slope of = +1/2 Note : m X m' = -1 , m= slope of line 1 ; m'= slope of perpendicular line to line 1
An 8 to 1 multiplexer (MUX) is a digital switch that selects one of eight input lines and forwards the selected input to a single output line based on three selection lines. The logic diagram consists of eight input lines (I0 to I7), three selection lines (S0, S1, S2), and one output line (Y). The selection lines determine which input is connected to the output, with each combination of the selection lines corresponding to one of the input lines. The logic gates used in the diagram typically include AND, OR, and NOT gates to implement the necessary connections and selection logic.
The point lies 1 unit below the regression line.
20 address line available in 16 to 1 multiplexer 16 for input lines and 4 will be selection lines.
It is the enable line. Used to enable the multiplexer to function. For low enable multiplexers, strobe is set to 0 to enable the multiplexer whereas in high enable multiplexers, it is set 1 to enable the multiplexer.
Personally describing VHDL code for multiplexer can be quite difficult without prior knowledge. It takes many VHDLs to be a multiplexer.
Jo MUX hai wo circuit ki tarah karya karta hai. adhik jankari ke liye csa ki book search kre. Deepak Shukla. Duble MCA-
Type your answer here... D0-D7 on 1st 8to1, D8-D15 on 2nd 8to1, S0,S1,S2 to both. The output from 1st 8to1 is D0 on the 2to1, the output from the 2nd 8to1 is D1 on the 2to1 and S3 to the 2to1. The 2to1 provides the final 16to 1 mutiplexed output, OK?
Use the multiplexer to choose the correct output based on the inputs (use the truth table).
A byte always contains 8 bit of information(A7, A6 ....A0) . In case you want to use only 4 bits (16 combination) of data then 2 such information can be stored/transmitted through 1 byte, so to select weather your useful data is A0, A1, A2, A3 or A4, A5, A6, A7 a nibble MUX can be used.For detailed help reply me at ishank4043@gmail.com
The straight line that best fits the data on a coordinate plane is the Line Of Best Fit.
f = ~s.a + s.b , thus is the function for a multiplexer. let a not gate with input x and output y. set a = 1 and b =0 to get a not gate. y = ~x.1 + x.0
help
using 8:1 mux....
"Divide line 1 by line 2" typically refers to a mathematical operation where the numerical value or expression represented by line 1 is divided by the value or expression represented by line 2. This operation can be used in various contexts, such as solving equations, calculating ratios, or analyzing data. The result will yield a new value that represents how many times line 2 fits into line 1.