0
What else can I help you with?
Gallon per minute through a half inch copper line?
It would be wonderful if you also gave the pressure and told about friction losses
How do you measure each line segment to the nearest half inch?
line segment to the nearest half inch is measured using the distance formula.
Can you make a triangle out of a 3 inch line a 2 inch line and a 6 inch line?
Yes. 3+2+6=11. If you divide 11 and 3, your answer is 3r2. You will have two 3 inch sides and one 5 inch side.
How long to fill a 55 gallon drum from a half-inch water line?
The answer depends on the flow rate or the water pressure, not just the pipe size.
What is a line that cuts a segment in half?
A line that cuts a segment in half is a bisector
What size brake fittings 1997 Jeep Wrangler?
1/4 inch line, 3/8ths fittings.
How do you attach a half inch brass line to a half inch copper shut off the brass is thicker than the copper?
By the use of Flagg Flow T.P Fitting adapters and Cx M or C x F adapters attached to the T.P fitting T.P = threadless pipe
Gallon per minute through a half inch copper line?
It would be wonderful if you also gave the pressure and told about friction losses
Can you use Teflon tape on brake line fittings and can you use standard tappered pipe fittings for hydrolic brakes with Teflon tape?
You do not need tape on any flared fitting, brake or regular. The brake line and the fittings are different size and thread type than regular copper line and fittings. You can't mix them.
How many outlets can a single half inch copper water line run at an average of 50 pounds of pressure before I notice a temperature and pressure change in the shower?
Not many. Maybe one at best. Half inch copper line is too small for most needs. 3/4 only costs a little more. You will go completely mad waiting for a bathtub to fill with half inch lines. Every flush of a toilet will make the shower die out.
How do you measure each line segment to the nearest half inch?
line segment to the nearest half inch is measured using the distance formula.
Supply lines half inch or three quarters?
Depending what you are wanting to supply. Basin, shower, toilet, bidet, kitchen can be fed with a half inch line Main line and bath can be fed with a three quarter inch line
How do you snake out a one inch drain line?
You dont as the diameter is to small to pass the fittings . We use Ram Jet or water jetting
How deep is the frost line in Gainesville Florida?
about a half an inch
What is the best way to connect a 1/4 inch copper tubing to a water supply line?
The best way to connect a 1/4 inch copper tubing to a water supply line is by using a compression fitting. This fitting allows for a secure and leak-proof connection between the tubing and the water supply line.
Procedure of indenting first line of each paragraph one-half inch from left margin?
To indent the first line of each paragraph one-half inch from the left margin, you can set the paragraph formatting to have a half-inch first line indent. This can typically be done in word-processing software like Microsoft Word by going to the "Paragraph" settings and adjusting the indentation options. Simply specify a 0.5-inch first line indent to achieve the desired formatting.
How can I repair a copper water line effectively?
To repair a copper water line effectively, start by turning off the water supply. Use a pipe cutter to remove the damaged section of the pipe. Clean the ends of the pipe and the fittings with sandpaper. Apply flux to the cleaned areas and solder the fittings onto the pipe using a torch. Allow the pipe to cool and then turn the water supply back on to check for leaks.
