answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How many seconds of gas post-flow for 130a?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How many seconds of gas postflow should be selected if the machine is set to deliver 130 Amps?

I don't


M40 gas mask donned cleared and sealed in 9 seconds How many addition seconds are given for hood?

additional six seconds


If it takes oxygen gas 12.5 seconds to diffuse from a container how long will it take sulfur dioxide gas to diffuse from the same container?

17.7 seconds


How many seconds would it take to get to the sun if you were going 55 mph?

you would run out of gas, so you would never get there


If it takes helium gas (He) 5 seconds to diffuse from a container, how long will it take oxygen gas (O2) to diffuse from the same container?

14.1 - 14.14 seconds


What makes your car stop after a couple of seconds it starts again?

The car ran out of gas, we put gas in the car and it won't run for longer than 3 seconds


How do you reset service light on Nissan 350z?

1. Turn the ignition to the "on" position 2. Wait three seconds, then press the gas pedal (very hard) 5 times within 5 seconds 3. Release your foot from the gas peddle for 7 seconds 4. Push the gas pedal down for 10 seconds (SES Light should start to blink) 5. Release the gas pedal for 10 seconds 6. Push the gas pedal again holding it down for 10 more seconds 7. Release the gas pedal and turn the ignition to "off" 8. Start the car, your ECU should now be reset.


How do you reset service light on 2003 Nissan 350z?

1. Turn the ignition to the "on" position 2. Wait three seconds, then press the gas pedal (very hard) 5 times within 5 seconds 3. Release your foot from the gas peddle for 7 seconds 4. Push the gas pedal down for 10 seconds (SES Light should start to blink) 5. Release the gas pedal for 10 seconds 6. Push the gas pedal again holding it down for 10 more seconds 7. Release the gas pedal and turn the ignition to "off" 8. Start the car, your ECU should now be reset.


How do start a 2007 Chrysler PT Cruiser when you run out of gas?

Put gas in the tank, and start cranking. Should start in a few seconds.Put gas in the tank, and start cranking. Should start in a few seconds.


How do you restart a 1997 Chrysler Sebring after running out of gas?

Add gas, crank engine. If it doesn't start in about 30 seconds, it was not out of gas and you have a different problem.


Why wont a 1986 CRX start or run for more then a few seconds?

Is there gas in it? if it runs for a few seconds make sure there is fuel in it


What takes 10 seconds today that took 20 seconds 1 year ago?

3/4 pump a gallon of gas