280 gallons of water.
22
150
45.9 US gallons.
pm is short for pico-meter, or 10-12 meter. That's a trillionth of a meter (using the short scale), or a billionth of a meter on the long scale.pm is short for pico-meter, or 10-12 meter. That's a trillionth of a meter (using the short scale), or a billionth of a meter on the long scale.pm is short for pico-meter, or 10-12 meter. That's a trillionth of a meter (using the short scale), or a billionth of a meter on the long scale.pm is short for pico-meter, or 10-12 meter. That's a trillionth of a meter (using the short scale), or a billionth of a meter on the long scale.
There need not be any water in the hose! Its capacity is approx 163461 cm3 or 163.5 litres.
The volume of water a pipe can hold can be calculated using the formula for the volume of a cylinder: V = πr^2h, where r is the radius and h is the height (or length) of the cylinder. In this case, the radius is half of the diameter, so r = 30/2 = 15 meters. Assuming the pipe is 1 meter long, the volume of water the pipe can hold is: V = π(15)^2(1) ≈ 706.86 cubic meters.
An atom is about 10-11 meter in diameter, so to make a chain of them 10-6 meter long you would need about 10-6/10-11 =105 or 100,000 atoms.
largest flower in world is Rafflesia armondi the diameter of this flower is one and a half meter long smallest flower in world is Woiffia microscopica
The volume would be 180,400 m3
A one by one by two meter tub has a volume of 2 square meters or 70.63 cubic feet. Such a volume will contain 528.3 gallons of water. At 8.345 pounds per gallon, the water in the tub will weigh 4409 pounds.
280 gallons of water.
22
6'' pipe 1 meter long how mach the watter volume
Unfortunately, the question does not state whether the diameter is 8 metres or 8 micrometres or some measure in between the two.
A meter stick is 1 meter long.
the weight should be change by the diameter of the rod.one rod length is thirteen meter and it should be measured in meter only. The formulae to find the weight of rod is d square /162 and you wil get unit weight then multiply it in length then u got a weight of the rod.