The Fast Fourier Transform is an implementation of the Discrete Fourier Transform. The DFT is a method of processing a time-sampled signal (eg, an audio wave) into a series of sines and cosines. As such, it is not a sorting algorithm, so this question does not make any sense.
Before you can solve for an average, you have to know the value that you want to solve for the average.
Distance travelled divided by time taken.
The mean means the average. To get the average, you have to add all of the numbers up and divide the sum by how many numbers are in the group that you are finding the mean of.
There is no meaningful average wen data are categorical (qualitative). Also, the arithmetic mean is not a good measure of central tendency when the data distribution is skewed.
I am not entirely sure I understand correctly what you mean by "essence". However, the idea of finding the standard deviation is to determine, as a general tendency, whether most data points are close to the average, or whether there is a large spread in the data. The standard deviation means, more or less, "How far is the typical data point from the average?"
one of the following:by finding its position and formby finding its speed and directionby finding its mass and speedby finding its height and width
For map reading and finding position you can Triangulate you position. With 2 known position and a unknown position you can figure out the unknown position on a map.
radar
You can transform them in various ways. These includes creating public awareness on these norms, holding seminars and workshop on the issue, finding people who share the same view as you.
It is usually a physicist.
Before you can solve for an average, you have to know the value that you want to solve for the average.
To calculate velocity from a position-time graph, you can find the slope of the line tangent to the curve at a specific point. This slope represents the instantaneous velocity at that point. Alternatively, you can calculate the average velocity over a specific time interval by finding the change in position divided by the change in time.
It is a right-lateral strike-slip fault
It is impossible to find an average. Finding an average requires 2 or more numbers but there is only 1 in your question.
Isotopes
Finding the average from the raw data requires a lot more calculations. By using frequency distributions you reduce the number of calculations.
To find the average of n numbers, take the sum of the numbers and divide by n.