Negative * positive = negative Positive * positive = positive Negative * negative = positive
Negative * positive = negative Positive * positive = positive Negative * negative = positive
A negative divided by a positive is negative. A negative divided by a negative is positive. A positive divided by a positive is positive. A positive divided by a negative is negative.
positive and a positive is a positive negative and a negative is a positive to answer your question: positive and a negative is a negative.
negative*negative=positive negative/positive=negative negative\negative=positve negative-positive=change the sign to a plus and then change the number after the sign and get your answer negative +positive=which ever numbr is bigger minus positive+positive=positive
Positively positive
Positive
You do not connect any wire from the alternator to the starter. The positive wire from the alternator should run to the positive on the battery, and the negative wire (if equipped) should run to the engine block (or any suitable ground). Most alternators are already grounded by the bolts holding them to the engine, but some do have a negative wire.
It Depends. Is is a new style alternator? or old generator? if it was the old style generator on the tractor it will be positive ground. If it was the alternator is is negative ground.
The positive cable is connected to the alternator and starter. The negative cable is connected to the chassis or engine ground. Positive is red and negative is black. The positive post is slightly larger than the negative post.
Disconnect the battery negative terminal. Remove serpentine belt. Remove bolts to alternator and positive cable at alternator and harness. Remove alternator. Reverse procedure to install.
get a multi meter that reads dc voltage & touch the black (negative -) wire to the negative battery post & the red (positive +) wire to the positive battery post with car running. car off is battery voltage, car on is alternator voltage.
unbolt the negative power wire unplug the positive power wore remove the tension bolt on the top of the alternator remove the lower bolt and pull out the alternator
Positive + Negative = Negative Negative + Negative = Positive Positive + Positive = Positive Negative + Positive = Negative
Negative * positive = negative Positive * positive = positive Negative * negative = positive
1. Remove the bolt retaining the negative battery cable to the alternator adjusting bracket, if so equipped. If not, disconnect the cable from the negative battery terminal. 2. Disconnect the cable from the positive battery terminal. 3. Disconnect the 2 electrical connectors from the rear of the alternator. 4. Remove the bolt retaining the alternator to the adjusting bracket. 5. Remove the alernator pivot bolt and remove the alternator from the vehicle. 6. Installation is reverse of removal, noting the following: 7. Reconnect the positive battery cable before reattaching the negative cable at the alternator bracket. 8. Adjust the alternator drive belt.
The rules for the sign (positive or negative) of the result of a multiplication is the same as division. For multiplication: Positive * Positive --> Positive Positive * Negative --> Negative Negative * Positive --> Negative Negative * Negative --> Positive For division: Positive / Positive --> Positive Positive / Negative --> Negative Negative / Positive --> Negative Negative / Negative --> Positive