You start from the first mark from the left of the ruler which is actually 0.
Between the 70 centimetre mark and the 90 centimetre mark.
1 cm = 10 mm. Start with ruler at 0 and mark ribbon at 30 cm. Then place ruler at the mark and measure 30 cm more and make another mark- you are up to 60 cm or 600 mm. Then place ruler at this mark and measure 5 cm, or 50 mm. Now you have a 650 mm ribbon.
On a standard ruler, 5.51 inches would be located between the 5-inch mark and the 6-inch mark. Each inch on the ruler is divided into 16 equal parts, so 0.51 inches would be slightly more than halfway between the 5-inch mark and the 6-inch mark. To locate 5.51 inches precisely, you would need to count 10 small divisions past the 5-inch mark.
cause it does
A 16-mark looks like a small vertical line that is slightly longer than the surrounding lines on a standard ruler. It typically falls between the 15-mark and the 17-mark on the ruler scale.
On a standard ruler, 1.5cm would be the distance between the 1cm mark and the 2cm mark. It's a relatively small distance and can be found by eyeballing or using the measurement markings on the ruler.
You start from the first mark from the left of the ruler which is actually 0.
0.1 centimetres on a ruler is typically located between the 0 and 1 centimetre marks. It is usually the first small mark after the 0 centimetre mark on a metric ruler.
the 9th mark on a ruler in inches is 9/16 inches for centimeters its 9/10 cm.
Hanging indent is the term for the bottom triangle at the 0 mark on a horizontal ruler.
Can Magistrate mark the document voluntarily if the complainant is not capable of telling anything about the nature of the document ?
0.83 on a ruler would typically be between the 3/4 inch mark and the 7/8 inch mark.
no need to know<>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Well, honey, 1.18 inches on a ruler is, surprise surprise, 1.18 inches long. I mean, it's not rocket science, it's just a smidge over an inch. So, there you have it, short and sweet.
It is 2/10 past the one inch mark on a ruler.
0.66 on a ruler represents 0.66 inches or 66 hundredths of an inch. It would fall between the 5/8 inch mark and the 11/16 inch mark on a standard ruler.