The "tiny lines" that make up an inch on a ruler are centimeters.
It depends: 8, 10, 16, 32 and, in precision rulers, 64.
On a typical inch ruler the smallest lines are 1/16th dimensions. The next biggest are 1/8th", then 1/4", and finally 1/2".
Five eighths of an inch on a ruler would be located between the half-inch mark and the three-quarter inch mark.
They denote different fractions of the inch. A good engineers ruler will have 64 ths, 32 nds 16 ths and 8 ths at least.
The "tiny lines" that make up an inch on a ruler are centimeters.
It depends: 8, 10, 16, 32 and, in precision rulers, 64.
On a typical inch ruler the smallest lines are 1/16th dimensions. The next biggest are 1/8th", then 1/4", and finally 1/2".
an inch ruler is 2.5cm and a cm is the same but smaller.....saichona
Five eighths of an inch on a ruler would be located between the half-inch mark and the three-quarter inch mark.
They denote different fractions of the inch. A good engineers ruler will have 64 ths, 32 nds 16 ths and 8 ths at least.
Different rulers may have different marks between the inches. There could be half inches, quarter inches, eighths, tenths, sixteenths, or even thirty-seconds of an inch. There may be more than one of these sets on the same ruler, and also, quite often, there are marks in the first inch or two that are not continued on the rest of the ruler.
Typically the smallest lines are a sixteenth of an inch apart. Some rulers may show thirty-seconds or sixty-fourths of an inch.
It's between the Seventh and the Ninth of an inch.
The millimeters on a ruler are the tiny lines in between each centimeter
Well, honey, 1.18 inches on a ruler is, surprise surprise, 1.18 inches long. I mean, it's not rocket science, it's just a smidge over an inch. So, there you have it, short and sweet.
It depends on your ruler and what units are on your ruler. To measure to the nearest inch just find the inch measurement and round up or down to get to the nearest inch in your measurement is between two whole numbers.