volume responsibility
The initial concentration affects the conductivity of a solution in a sense that the greater the initial concentration,the greater the conductivity.increase in concentration means presence of more free moving ions in the solution.but this can only occur in the initial concentration because,after the initial concentration,an increase in concentration will mean that there are now more ions present in the solution but the same volume,hence the ions wouldn't be able to move freely an in the initial concentration,hence the conductivity would then decrease since they can't move freely now.
Mean
the volume of water means CA
What does volume mean on newsletters? Volume 1, Issue 5. When does it become volume 2?
Final volume minus initial volume refers to the difference between the volume at the end of a process or measurement and the volume at the beginning. It indicates the change in volume that occurred between the two points.
initial molarity*initial volume= final molarity*final volume Initial molarity= 1.50M Initial volume= 20.00ml Final Volume=150.0ml Thus final molarity =1.50M*20ml/150ml=0.200M. New molar concentration= final molarity
To measure volume using water displacement, you fill a graduated cylinder with a specific volume of water, note the initial volume, then submerge the object in the water. The increase in water level is the volume of the object. Subtract the initial volume from the final volume to get the volume of the object.
Subtract the initial from the final
To find the final concentration of a solution after dilution, you can use the formula: (C_1V_1 = C_2V_2), where (C_1) is the initial concentration, (V_1) is the initial volume, (C_2) is the final concentration, and (V_2) is the final volume. Plug in the values for the initial concentration, volume, and final volume to calculate the final concentration of HCl.
The initial volume of laughing gas depends on the specific context or experiment being referred to. In a typical scenario, the initial volume of laughing gas could be determined by the amount of gas initially present in the container before any changes occur.
Using the ideal gas law (PV = nRT), you can calculate the initial and final number of moles of CO2. Given that the temperature remains constant, the ratio of the initial volume to final volume is equal to the ratio of the initial pressure to the final pressure. Applying this ratio to the initial volume of 1.25 liters will give you the final volume.
If the initial volume is smaller than the final volume, this suggests that there has been an increase in volume. This could be due to factors such as expansion of a substance when heated, addition of more material, or a phase change from a more condensed state to a less condensed state.
The initial reading of the buret does not have to be exactly at 0.00 mL before starting titration because the volume of the reagent added should be based on the difference between the initial and final readings. As long as the initial reading is recorded accurately and consistent with subsequent readings, the final volume added can be determined correctly.
You can calculate pressure and temperature for a constant volume process using the combined gas law.
Charles's Law states that the volume of a gas is directly proportional to its temperature at constant pressure. Boyle's Law states that the pressure of a gas is inversely proportional to its volume at constant temperature. Both laws describe the behavior of gases under different conditions.
1. Put water into a measuring container and record the initial volume of the water. 2. Put the solid into the water. 3. Record how much the water has risen by. 4. Subtract the initial water volume from the risen water volume.