answersLogoWhite

0

M 14 1.25

User Avatar

Wiki User

13y ago

What else can I help you with?

Continue Learning about Math & Arithmetic

What size hole for a half inch tap?

For a half-inch tap (specifically a 1/2"-13 tap, which is common for coarse threads), the recommended drill bit size is typically 27/64 inches, or approximately 10.7 mm. This size provides the appropriate clearance for the tap to create threads in the material. Always consult a tap drill chart for specific applications, as fine thread taps may require different sizes.


What is the tap drill size for a 120-80 thread?

The tap drill size for a 120-80 thread is typically 0.086 inches (or 2.18 mm). This size allows for proper engagement of the threads when tapping a hole for a 120-80 screw. It's important to ensure that the tap drill size is accurate to achieve the desired thread strength and fit. Always refer to specific tapping charts or guidelines for confirmation based on materials and applications.


What size drill is used for a 6-48 tap?

For a 6-48 tap, a #43 drill bit is typically used. This size provides the appropriate clearance for the threads created by the tap. It's important to ensure proper sizing for effective tapping and to avoid damaging the material. Always check specific tapping guidelines for the material being worked on, as recommendations may vary slightly.


Can a 8in weldolet be welded on 8in pipe?

There are size on size weldolets. The hold on the run pipe will necessarily be undersize (either hot tap or torch ) because it's not possible to cut the same size hole in the run without damaging the base material.


When a guy asks you what size are you what does he mean?

He means what size bra you wear