transist means to make a change - you can transist from school to home at the end of the day.
transit is the adjective for transportation - a transit system (meaning buses or trains)
or it means it is coming now on its way going to crap in our hair.
No, but sometimes "average" means "mean" - when it doesn't mean median, geometric mean, or something else entirely.
The answer will depend on who you mean by HE.The answer will depend on who you mean by HE.The answer will depend on who you mean by HE.The answer will depend on who you mean by HE.
There is no statistical term such as "deviation mean".
See mean-8. Or get a dictionary.
The mathematical term for "mean" is "mean".The popular, or colloquial term for "mean" is "average".
it is possible to make a microwave diode exhibit negative resistance by having delay between voltage and current in an avalanche together with transist time through the material . such devices are called avalanche transist time device. these are of 3 types 1. IMPATT 2. TRAPATT 3. BARITT
they amplify the phone's incoming signal
Free on board means the seller doesn't charge anything to load the item onto the carrier. Once loaded, the ownership of the item switches to the buyer. The buyer is then responsible for freight charges to the destination and also would be responsible for freight claims if the item were damaged in transist.
AS A TRANSISTORIT TRANSIT (CARREER), STOP OR PASS SIGNAL /CURRIENT/VOLT ETC. TROUGHT ITANDALL UNDER CONTROL WHEN IS PERFORMING IN GOOD CONDITON. WHEN IT IS DEFECTIVE THREE TINGS MIGHT OCCUR: 1:DOS NOT TRANSISTAT ALL EVEN WHEN SUPPOSE TO PASS CURRIENT/SIGNAL ETC. 2: TRANSIST PERMANENTLY (PASS) AT ALL TIME EVEN WHEN NO SUPPOSE TO DO IT 3: CAN SET IT SELF IN FIRE DUE TO THE OVER HEATING
put (programmable unijunction transistor) he Programmable Unijunction Transistor behaves much like a unijunction transist or (UJT), but is "programmable" via external resistors (that is, you can use two resistors to set a PUT's peak voltage). Note that the name is a bit of a misnomer -- as a thyristor, it is a four layer device, unlike a true unijuncti on transistor which has but two layers. Like other thyristors, a PUT looks much like a junction transistor with a fourth layer and therefore a total of three P- N junctions. Meanwhile, a third terminal, the gate (G), makes a PUT function like a hybrid of transistor and diode: PUT symbolPUT cross-section PUTs are not often used in BEAM; they're essentially special-purpose devices in electronics, used for lightingcontrol, motor speed control and othervariable power applications. In combination with an SCR they can, though, makea mean solar engine. In a pinch, you can build up something much like a PUT from discrete transist ors wired as a complementaryfeedback Here, as soon as any current flows in either transistor, this current becomes base current for the other transistor, and both transistors turn on hard. This means you can only build up this circuit using low-leakage transistors ('though this should be the case with any decent- quality modern transistor ).
you mean what you mean
Mean is the average.
It mean what you don't what does it mean.
The arithmetic mean is a weighted mean where each observation is given the same weight.
The correct usage is "what DOES it mean"
The haudensaunee mean irguios
It seems like you may be referring to "aumred" as a term that is not commonly recognized or defined. Without additional context or information, it is difficult to provide a specific meaning for this term. If you could provide more details or clarify the context in which "aumred" is used, I would be able to offer a more accurate explanation.