The answer is larger than the original number.
The quotient is larger than the original fraction.
It increases.
An integer that is larger than zero.An integer that is larger than zero.An integer that is larger than zero.An integer that is larger than zero.
Multiply them by a number larger than its reciprocal.Multiply them by a number larger than its reciprocal.Multiply them by a number larger than its reciprocal.Multiply them by a number larger than its reciprocal.
The fuse is there to protect the wiring in your home not the microwave. Using a larger fuse than required for the wiring causes a fire hazard. You can end up burning your home down. Use only the fuse recommended.
Absolutely not. The fuse is there to protect the wiring. Installing a larger fuse than required will remove that protection and could cause a fire. You can go with a smaller fuse but never a larger fuse.
The fuse panel is under the rear seat. The window fuse is in the #57 spot. It is a metal fuse breaker and is larger than the regular fuse. Should be a 30 amp though.
No, you should never replace a fuse with anything larger. The fuse is designed to handle the capacity of the wire and the devices on the circuit; if the fuse keeps blowing it means that there is a fault somewhere on the circuit and the faulty device should be repaired/replaced rather than using a larger fuse. Using a larger fuse will result in damage to the wiring and possibly cause the vehicle to catch fire.
Usually nothing larger than 3 amp fuse. Under normal use 2amp fuse will work perfectly....
Whatever was installed at the factory. Your owners manual will list the correct size fuse. Do not install a larger fuse than came in the car.
The answer is larger than the original number.
The quotient is larger than the original fraction.
On a current surge that is larger than the rating amperage of the fuse, the link in the fuse melts and opens the circuit thereby stopping the current flow.
The power windows are not run with a fuse. They use a circuit breaker. It should still be in the fuse box but will be much larger and look different than the typical fuse. It may be labled "pwr accsy".....or something like that.
No, you cannot replace a 10-amp fuse with a 20-amp fuse. Fuses are meant to guard your wiring and equipment by melting or 'blowing' before the wiring, itself, melts and causes a fire. It is safe to use a smaller fuse than called for, but never, ever is it safe to use a larger fuse than called for.
No, if it has a fuse then that is the protection for that circuit. If the fuse keeps blowing then you are either using too small a fuse or you have something wrong with that circuit. Short inn the circuit or it is overloaded. Make sure you are using the correct size fuse and do not use a larger fuse than required.