Diameter
Draw a circle with radius of 12 units and draw the horizontal diameter. Draw the perpendicular bisector for this line. Bisect the angle that is formed above the horizontal line. Again, bisect the angle that is formed above the horizontal line: extend this line to the circumference of the circle. This line will be 12 units long because it is a radius of the circle. It is a quarter (half of half) of the 90 degree angle and so the incline is 22.5 degrees.
A horizontal line.A horizontal line.A horizontal line.A horizontal line.
Circle
yes _________ there is a horizontal line for ya!
To make perpendicular lines, draw a horizontal line. Then using a compass or tracing around the edge of a curved object, draw one circle ( or just a semi-circle) so that it crosses the horizontal straight line in at least one point. Now rotate the compass or move the curved object to draw another circle (or semi-circle). This second circle (or semi-circle) must cross through the horizontal straight line as the first one did. It also must cross through the first circle (or semi-circle) at two points- above the horizontal straight line and below the horizontal straight line. Next, draw a straight line from where the two circles (or semi-circles) meet above the horizontal straight line through to where they meet below the horizontal straight line. You now have a line perpendicular to the first line.
Diameter
The circle and the square are the two parents.
A red circle with a white horizontal line means no entry. this means the road only goes in 1 dirrecdtion.
In a pedigree:=a square means male, a circle means female, an unshaded circle means that doesn't have traits and a shaded square means has traits.==the horizontal line describe that they are parents and vertical line describes that they are the offspring of that parents.=
Make a horizontal line and vertical line through the circle. You now have 4 parts. Make a line from the center to the edge of the circle in 3 of these parts and you now have 7 parts.
Draw a circle with radius of 12 units and draw the horizontal diameter. Draw the perpendicular bisector for this line. Bisect the angle that is formed above the horizontal line. Again, bisect the angle that is formed above the horizontal line: extend this line to the circumference of the circle. This line will be 12 units long because it is a radius of the circle. It is a quarter (half of half) of the 90 degree angle and so the incline is 22.5 degrees.
To divide a circle into fifths, you would start by drawing a horizontal line through the center of the circle to create two equal halves. Then, draw another line perpendicular to the first line to divide the circle into quarters. Next, draw a line at a 72-degree angle from the horizontal line to create one-fifth of the circle. Repeat this step four more times, each time rotating the angle by 72 degrees to divide the circle into fifths.
No entry (do not enter.)
If the cylinder is standing on its flat face, the horizontal cross section is a circle. Otherwise, it is a line or a rectangle.
A horizontal line.A horizontal line.A horizontal line.A horizontal line.
1) draw a circle 2) put on line from bottom of circle 3) put horizontal line through line as long as the other one 3) from bottom of vertical line put two lines 90