A current that runs parallel to the shoreline is called a rip tide or rip current.
The line that cuts a parallel line is called a TRANSVERSAL. When you have parallel lines and you want to show like corresponding, vertical, ect.... then the line that cut through the parallel lines is a TRANSVERSAL
Line a is parallel to line b, m, and . Find .
A vertical line has an undefined slope. For the line to be parallel to a vertical line, the slopes would have to be the same. Therefore, the line parallel to a vertical line also has an undefined slope.
draw line st parallel to line mn
I classify a parallel line as two line segments that will never intersect if the line kept going. They are perfectly straight and even.
The current in the main line is the same as the current in the parallel branches because of Kirchhoff's current law, which states that the total current entering a junction must equal the total current leaving the junction. Therefore, the current entering the parallel branches from the main line is the same as the current returning to the main line from the parallel branches.
The line current increases when more bulbs are switched on in parallel, since more parallel current paths results in lower effective resistance. The line voltage should not change in response to any normal use of electric power in a single house.
The current is the amperage. It is measured in series. Voltage is measured across the line (parallel).
Yes, an open in main line of a parallel circuit will effect the entire circuit current and make the whole circuit current zero
The clamp on amp meter has to go around both of the parallel conductors to get an accurate reading of the line current. If you are using a current transformer, both wires have to go through the centre hole in the transformer.
Shore Line East was created in 1990.
[A Parallel line is a straight line, opposite to another, that do not intersect or meet.] Ie. Line 1 is Parallel to Line 2. ------------------------------------------------- <Line 1 ------------------------------------------------- <Line 2
The line that cuts a parallel line is called a TRANSVERSAL. When you have parallel lines and you want to show like corresponding, vertical, ect.... then the line that cut through the parallel lines is a TRANSVERSAL
Line a is parallel to line b, m, and . Find .
Shore Line Railway - Connecticut - ended in 1897.
Shore Line Railway - Connecticut - was created in 1864.
Do you mean "Why might a parallel line algorithm be needed?" or "What properties does a parallel line algorithm need to have?".