no a lap is down and back
The answer depends on the length of a lap: a lap of a running track will be considerably larger than a lap of a swimming pool!
A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.
0.25l, 0.3l
I'll assume you are talking about an olympic track of 400m lap length. 375/400 is 15/16 of a lap
The difference between the two is in the application. A development length is the amount of rebar length that is needed to be embedded or projected into concrete to create a desired bond strength between the two materials. The lap splice length is the length two rebar pieces must overlap and be tied together to create a bond as if there was no break and the run is "continuous". So simply put, development is rebar to concrete, splice is rebar to rebar. The lengths of both splice and development do vary. They are dependent upon different factors. These include but are not limited to concrete strength, rebar size, rebar coating and concrete cover or clearance. So when you see a chart on one project, it can differ from another for these reasons.
lap length in tension including anchorage value of hooks in flexural tension shall be greater of development length or 30 times dia of bar. In compression, its equal to development length. In general, 50 times dia is provided.
The length of a lap in a footrace is 400 meters. I should know I run it.
no a lap is down and back
Lap length is the length overlap of bars tied to extend the reinforcement length.. Lap length about 50 times the diameter of the bar is considered safe. Laps of neighboring bar lengths should be staggered and should not be provided at one level/line. At one cross section, a maximum of 50% bars should be lapped.In case, required lap length is not available at junction because of space and other constraints, bars can be joined with couplers or welded (with correct choice of method of welding).
The lap length for welding a reinforced bar will depend on the size of the bar that is being welded. If the bars are different diameters when lapped, the lap length should be calculated using the lesser diameter.
not sure but i think that they continud the lap over and the first one to finish would win
The answer depends on the length of a lap: a lap of a running track will be considerably larger than a lap of a swimming pool!
A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.
my big hole
0.25l, 0.3l
An Olympic pool is 50 meters in length so 50 meters would be one length of the pool .