no a lap is down and back
lap length is the inside dimension of a pool whereas the Development length is the dimension of the hole required to build the pool.
The answer depends on the length of a lap: a lap of a running track will be considerably larger than a lap of a swimming pool!
A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.A lap is not a standard unit of length and so the question cannot be answered. For example, a lap ina swimming pool will be quite different to one on a track field.
you have to figure out length times width to get the formula for diagonal length suckers
Formula to calculate length of spiral reinforcement in columns
yes, joint measurement for laps should be recorded
if the bar length is 5o m , what will be the actual length including lap length
Lap reinforcement is needed because if lap is not given in a steel structure,that portion will be filled only with mass concrete and it will not attain the expected strength,so inorder to prevent that we can provide a lap rod whose length is 50D i.e 50 times the diameter of the rod.
40 times diameter
when length of reinforcing bar is small and we have to provide longer reinforcement in that case the second bar is provided with proper overlapping with the first bar this overlapping is known as lap length. the straight length of shall not be less than 12mm dia and 200mm length.
Lap length is the length overlap of bars tied to extend the reinforcement length.. Lap length about 50 times the diameter of the bar is considered safe. Laps of neighboring bar lengths should be staggered and should not be provided at one level/line. At one cross section, a maximum of 50% bars should be lapped.In case, required lap length is not available at junction because of space and other constraints, bars can be joined with couplers or welded (with correct choice of method of welding).
one trapozoidal section of 0.5 sloping distance is one side and 0.5 is the another side and 1.0 meter is the horizontal base . what will be the cutting length for it.
The length of a lap in a footrace is 400 meters. I should know I run it.
no a lap is down and back
lap length is the inside dimension of a pool whereas the Development length is the dimension of the hole required to build the pool.
Lap Length is the length overlap of two rebars tied to extend the reinforcement length. Lap Length of about 50 times the diameter of the bar is considered safe. Let us understand the term “lap length” with an example: suppose there is a need to build a 200ft tall structure, say column. We know that for convenience of transportation, standard length manufactured are upto 12 metre only, hence to strengthen the structure overlapping of two or more bars are done side by side upto the design length. Reason for doing so is the required tension forces that is needed to transferred from one bar to the other. So if diameter of tmt is A then lap length will be 50A. If both diameter is same. Now coming to question, lap length of tmt 550 grade is usually done where minimum bending stress is encountered. We at Shree Ji Steel offer wide range of sizes and grade for various product range which can be checked from our website Shree Ji Steel Corporation.