The equivalent gauge of 18 mil is approximately 20 gauge. In general, mil is a measurement of thickness equal to one-thousandth of an inch, while gauge is a standard measurement used for various materials, including metal and plastic. The conversion between mils and gauge can vary depending on the material being measured.
A thickness of 68 mil is equivalent to 0.068 inches. In terms of gauge, this measurement falls around 16 gauge in the standard gauge conversion for metal thickness, although variations can occur depending on the material being measured. Generally, mil is a term used primarily in the context of plastic sheeting and other materials, where 1 mil equals 1/1000 of an inch.
To compare thicknesses, 20 mil is equivalent to 20 thousandths of an inch, while 13 pt (points) is equivalent to 13/72 of an inch, which is approximately 0.1806 inches or 18 mil. Therefore, 20 mil is thicker than 13 pt.
The gauge system varies depending on the type of measurement being referenced, such as wire gauge or sheet metal gauge. For example, in the American Wire Gauge (AWG) system, 1 mm is approximately equivalent to 18 gauge. In sheet metal, 1 mm is roughly equivalent to 18 or 20 gauge, depending on the material. Always check specific gauge charts for precise conversions.
Gauge is the term that comes to mind, such as 12 gauge (ga.) wire. With plastic bags, one might use mil, such as a 3 mil garbage bag. "Mil" indicates thousandths of an inch.
.001 inch = 1 mil
The ratio of gauge to mil in plastic thickness is 1 gauge = 0.1 mil. This means that for every 1 gauge increase, the thickness increases by 0.1 mils.
A thickness of 68 mil is equivalent to 0.068 inches. In terms of gauge, this measurement falls around 16 gauge in the standard gauge conversion for metal thickness, although variations can occur depending on the material being measured. Generally, mil is a term used primarily in the context of plastic sheeting and other materials, where 1 mil equals 1/1000 of an inch.
Convert gauge to mil
To compare thicknesses, 20 mil is equivalent to 20 thousandths of an inch, while 13 pt (points) is equivalent to 13/72 of an inch, which is approximately 0.1806 inches or 18 mil. Therefore, 20 mil is thicker than 13 pt.
no
The gauge system varies depending on the type of measurement being referenced, such as wire gauge or sheet metal gauge. For example, in the American Wire Gauge (AWG) system, 1 mm is approximately equivalent to 18 gauge. In sheet metal, 1 mm is roughly equivalent to 18 or 20 gauge, depending on the material. Always check specific gauge charts for precise conversions.
Gauge is the term that comes to mind, such as 12 gauge (ga.) wire. With plastic bags, one might use mil, such as a 3 mil garbage bag. "Mil" indicates thousandths of an inch.
0.25
.001 inch = 1 mil
18 gauge
18 gauge is thinner than 10 gauge.
Gauge and mil refer to the thickness of the liner. To find the thickness when listed by gauge ask for the type of material and check for the converted value ( ie a 10 gauge liner may equate to perhaps a 0.14 inch thickness material , 8 gauge may be 0.12 inches etc ) The mil value usually refers to a millimeter thickness (ie 15 mil should be thicker than a 10 mil ) >KEEP IN MIND THAT THE MIL NUMBER IS NOT IN INCHES , so make sure what the mil value is given in millimeters or inches then you can compare the different thicknesses. If the pool dealer doesnt know the difference you may want to find another dealer