answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What is the function of the resitor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How changer blower resitor bmw 735il 1988?

Blower moto resitor


A current of 6A flows through a resitor with a difference of 2V?

R = E/IThe resitance of the resitor is (2/6) = 1/3rd ohm.


1993 buick lesabre wipers only work at low speed why?

The resitor is probably burnt out on the high mode


Where is the fuel pump ballast resitor located. on 94 jeep cherokee larado 4.0 4wd?

Top, drivers side fender


What resistor can you use to replace a 47 kilo-ohm resitor?

You should use the same size resistor; a 47 kilo-ohm.CommentThe correct spelling is 'kilohm'.


How do you disengage the anti theft system to be able start the car when the chip on the key is bad?

I am not familar with how to disengage the anti thief it is a resitor or chip,Get one made at the dealership you will need your VIN and some ID.


2004 trailblazer blower motor resistor location?

i had a 03 Chevrolet Colorado, and the resitor was located under the glove compartment, where the motor blower is, the resistor is screwed to the side of the blower. hope this works for you. the resistor is usually located there.


The ac in my car stopped blowing the air at the regular intervals 1 2 3 4 no matter what number its on it blows the same it comes out cold but doesnt blow the way it should AND THE BLOWER IS WORKING?

the thermo-resitor is burned out


How capacitor and resitor in a circuit effect the phase of input voltage?

A capacitor and a resistor has no effect on the supply voltage; however, this particular load combination will cause the load current to lead the supply voltage by some angle termed the 'phase angle'.


Aircondition works on Ford Taurus when set on high?

What you might be refering to is that the fan only works on high if this is the case your problem would be the blower motor resistor. this resitor is found on the blower motor casing it's about 2 inches long


Explain step by step how to put in the blower resitor?

Remove the electrical connector from the old resistor. Remove the screws holding the resistor in place. Remove the old resistor. Put in the new one and screw in the screws. Attach the electrical connector.


Replacing the starter on a 1990 Chevy pickup the new starter has 2 choices for the second small wire not the positive to attach too one marked S and one marked R which is correct?

mark s is for start mark r is resitor