A function has a "local minimum point" at a point p where there exists at least one positive number e having the property that the value v of the function for any point q for which the absolute value of q - p is greater than 0 but not greater than e, the value of the function at q is greater than or equal to the value at p.
If the coordinates of a point, before reflection, were (p, q) then after reflection, they will be (-p, q).
A sphere of radius R surround a point charge Q, located at its center afind the electric flux ?
It would have been possible to give a simple answer if we could see what proportion of the way from A to B the question was about. But, thanks to the wonderful (not!) browser used by this site, we cannot and so this is a general answer.If the question was about p/q of the way, then the coordinates of the point are [(14*(q-p) + 4*p)/q, (1*(q-p) + 23*p)/q].
Usually a tiny black spot.
Q
"http://wiki.answers.com/Q/What_is_the_importance_of_business_education"
"http://wiki.answers.com/Q/What_is_the_importance_of_PR"
depending on the graph where point Q was you would not be able to tell where point Q ended after the rotaion finshed
ewn q sau
"http://wiki.answers.com/Q/What_is_the_importance_of_business_education"
http://wiki.answers.com/Q/What_is_the_importance_of_depositer_to_a_bank" [
The operating point of a transistor is called the Q point because Q stands for "quiescent," which means a state of rest or inactivity. It represents the DC bias conditions at which the transistor operates when there is no input signal. This point is crucial for analyzing the transistor's behavior and ensuring proper amplification.
If (p, q) is any point on the line, then the point slope equation is: (y - q)/(x - p) = 2 or (y - q) = 2*(x - p)
selection of q-point is necessary in amplifiers,because if the q-point is not in the middle of load line the output may be clipped i.e not in the power supply range.
Q point is also called operating point.Q point is mainly adjusted in transistors to make it stable. i.e., to operate the transistor in safe mode. Depending up on the operating current and voltage Q point is adjusted. The Q point defines the operating condition of the transistor and the transistors which quiescent point is adjusted are denoted as Q1,Q2.........Qn
Write a comprehensive note the importance of sensorial exercises.