0
What else can I help you with?
What is the minimum diameter for the primary flow and return pipe work to a direct cylinder is?
The minimum diameter for the primary flow and return pipework to a direct cylinder is typically 22mm. This size is generally sufficient to ensure adequate water flow and heat transfer for most domestic hot water systems. However, specific requirements may vary based on the system's capacity and design, so it's essential to consult local regulations and manufacturer guidelines for precise specifications.
1992 accord lx which is the return line on the resevior for power steering flush there is 1 in bottom and 2 sligthly above right or left thanks?
the return line is usually the one smaller in diameter.
What happens if the IRR is greater than the required rate of return?
The IRR rule states that if the internal rate of return (IRR) on a project or investment is greater than the minimum required rate of return - the cost of capital - then the decision would generally be to go ahead with it. Conversely, if the IRR on a project or investment is lower than the cost of capital, then the best course of action may be to reject it.
Write a Program that reads radius of circle and prints the circle's diameter?
#include using std::cin;using std::cout;using std::endl;int main(){double radius = 0;cout radius;cout
What is pick up value and reset value of an electromechanical relay?
The pick-up value of an electromechanical relay is the minimum current or voltage required to activate the relay and close its contacts. In contrast, the reset value is the minimum current or voltage needed to de-energize the relay and return it to its original state. These values are crucial for ensuring proper operation and timing in control circuits, as they determine the relay's responsiveness to input signals.
What is the minimum diameter for the primary flow and return pipe work to a direct cylinder is?
The minimum diameter for the primary flow and return pipework to a direct cylinder is typically 22mm. This size is generally sufficient to ensure adequate water flow and heat transfer for most domestic hot water systems. However, specific requirements may vary based on the system's capacity and design, so it's essential to consult local regulations and manufacturer guidelines for precise specifications.
When a corporation weighs its return on investment for initiating a new project against the minimum standard investment return it has set before it the minimum standard investment return is referred t?
Hurdle rate
What is the best minimum size for a desk return?
24x48 in.
What is minimum rate of return?
It is the lowest return on project or investment that will make the firm or investor to accept that project.
Where to install air separator in primary circuit of variable primary and secondary chilled water air conditioning systems?
If you have a primary /secondary, the chilled water should be constant at the primary loop. The secondary can be variable. The air seperator is always connected at the return water side and is most likely very effective at the primary return. However is a must as well on the return side of the secondary.
What is minimum attractive rate of return?
It is the lowest return on project or investment that will make the firm or investor to accept that project.
Return on assets ratio pyramid showing primary secondary and tertiary ratios?
Primary ratio = Net income/Total assets
What are the typical minimum deposit requirements for high interest savings accounts?
I have found to get more than 1.5 % return on savings, you need a minimum of $10,000 to be invested.
Is there a minimum income in Indiana where you are not required to file a return?
http://www.in.gov/dor/3815.htm
The cost of capital is the minimum return a project has to earn in order for it to be accepted True or False?
true
How can I get better in money market checking?
Many money market accounts have a minimum dollar amount to achieve a minimum rate of return. The maximum rate of return will differ from site to site but should be clearly explained in the application process. Read the application carefully.
What is the difference between the required rate of return and the expected rate of return in investment analysis?
The required rate of return is the minimum return an investor needs to justify the risk of an investment, while the expected rate of return is the return that an investor anticipates receiving based on their analysis of the investment's potential performance.
