Let r be the angle of the ray, and R the angle of reflection.If the wall is flat (i.e., if its angle is 0), then we know that r + R = Pi/2.Now suppose the wall has angle w. Then rotate the diagram by -w,so that the wall is now flat again, and the angles of the ray and itsreflection are now r - w and R - w, respectively.We then have (r - w) + (R - w) = Pi/2, which should give you enoughinformation to find R.
The answer will depend on the value of r.The answer will depend on the value of r.The answer will depend on the value of r.The answer will depend on the value of r.
To convert U vals To R Vals 1/u = r val
R+14=39
In the equation g = rz, r represents a variable or a constant value. The specific value of r would need to be provided in order to determine its numerical value in the equation.
"R" is a value associated with heat penetration. The thickness of a material (for example, typical pink panther insulation) of any "R-value" will vary. If, for example, your wall space involves either a 2"x4", 2"x6", or even 2"x8" wall space then the material you insulate with will, of course, vary in size, however the "R-value" of your material will remain its rated value.
R 13 for 3.5" wall cavities, R19 for 5.5". R30 for blown in insulation and batts in ceilings.
A galvanized steel wall is superior to plywood. A fiberglass (polymer) wall is far superior to both. Good luck with your pool.
u r right...
To provide the same insulation value as 3.5 inches of fiberglass, a concrete wall would need to be approximately 15-18 inches thick. Concrete is a poor insulator compared to fiberglass, so a much thicker wall is needed to achieve similar insulation properties. Alternatively, adding insulation material within the concrete wall can help improve its insulating capabilities.
Its not superior
A wall cavity with a reflective surface has a higher R-value because the reflective surface reduces radiant heat transfer by reflecting heat back towards its source, thus improving the thermal performance of the wall assembly. This can help reduce heat loss in the winter and heat gain in the summer, making the insulation more effective overall.
superior mesenteric
You appreciate and value everything your superior says?
Sternomastoid, lying in the neck, is well superior to rectus abdominis which lies in the anterior abdominal wall.
While drywall, or gypsum board, does give insulation value it is not a high amount, a 1/2" piece of drywall will only raise the r-value by .45, if you are looking to improve the insulation of a wall you are much better off using rigid foam insulation. An extruded polystyrene board, that's Styrofoam, of 1" thickness gives you an R-value of 5.00, which is over 5 times greater per inch than that of drywall. You can further improve the insulation value of a wall by add some kind of batt insulation in-between the studs.
see http://www.k-mac-plastics.net/data%20sheets/ATG-014S1.pdf i believe it is 1/3 for .325 inch thick