As per the Maharashtra Pollution Control Board (MPCB) guidelines, the stack height for a 1000 kVA diesel generator (DG) set is typically required to be at least 8 meters above the ground level. However, this height can vary based on additional factors such as the location, type of fuel used, and any specific local regulations. It is advisable to consult the most recent MPCB guidelines or seek approval from the relevant authorities for precise requirements.
To find the change in height per second, we divide the total change in height by the total time taken. In this case, the change in height is 5000 feet and the total time is 200 seconds. Therefore, the change in height per second is 5000 feet / 200 seconds = 25 feet per second.
25 dimes x 10 cents per dime = $2.50
3lb per sqinch
A stack of pennies is approximately 1.52 mm high. To convert 5 inches to millimeters, multiply by 25.4, which equals about 127 mm. Dividing 127 mm by 1.52 mm per penny gives roughly 83 pennies in a 5-inch stack.
I have heard that there are $232 per inch.
what should be height of stack of 1250 kva D.G as per Indian pollution boardA: it should be 7.1 meter + building height of 1250kva Dg set installed.
In both kernel and User level they have one stack per thread
You can not change your height as per your weight. You have to change your weight as per your height.
No, you cannot stack attacks in Exploding Kittens. Each player can only play one attack card per turn.
To find the change in height per second, we divide the total change in height by the total time taken. In this case, the change in height is 5000 feet and the total time is 200 seconds. Therefore, the change in height per second is 5000 feet / 200 seconds = 25 feet per second.
1000 per year
The value of the stack would depend on how worn the dimes are. If you accept that a US dime is between 1.35 and 1.40 mm thick, then the value of the stack would worth between $264.30 and $274.00. 37cm * 10 mm per cm / 1.35mm = 2740074074074074 ~ $274.00 37cm * 10 mm per cm / 1.40mm = 264.285714285714 ~ $264.30
25 dimes x 10 cents per dime = $2.50
3lb per sqinch
A stack of pennies is approximately 1.52 mm high. To convert 5 inches to millimeters, multiply by 25.4, which equals about 127 mm. Dividing 127 mm by 1.52 mm per penny gives roughly 83 pennies in a 5-inch stack.
0.42 inches per foot.
why not ? a 1000kva means you will get the power out as 1000kv per amp in essence it can be a 100v with 10 amp out. means the same thing to me. It's power factor depends upon the load. Thus we can not give absolute value of KW rating of a Xmer or an alternator in the manufacturing plant.